Installation Instructions
1 | P a g e
v 1 . 0 ( 1 1 / 2 0 1 8 )
CORIAN TABLE LAMP
SKU# 269385, 269386, 269387
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep the instructions for future reference.
Warranty
•
This luminaire is covered by a 12 month warranty from the date of purchase. Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation Requirements
•
Select a suitable location for this luminaire:
- This product is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not installed in direct line of an air vent/system.
- If the luminaire is placed in an area prone to moisture, ensure that the area is well ventilated and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
•
Do not exceed the maximum wattage rating.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
•
Do not plug into the mains power socket outlet before or during assembly. Only do so after the portable lamp is fully
assembled with the globe installed and is ready to use for the first time.
Installation Directions
1. Remove all packaging material from the product and fabric lamp shade (A).
2. Remove the lamp holder ring (C) from the lamp holder (A).
3. Install the fabric lamp shade (A) onto the lamp holder (D) and secure using the lamp holder ring (C).
4. Install a globe (B - not included) into the lamp holder. Do not exceed the maximum rated wattage.
NOTE: This fitting is suitable with dimmable globes only. It is NOT suitable to use with 3 step dimmable
globes.
5. Select a suitable location for the luminaire. See the installation requirements above.
6. Insert the plug (G) into the mains power socket outlet and ensure it is fully plugged in.
7. Turn power on at the mains power socket outlet.
8. This luminaire has a 3 step dimming function, operating in the following order:
•
Touch the luminaire body (H) once, and the luminaire will turn on and light up at 30% brightness.
•
Touch the luminaire body (H) a second time, and the luminaire will light up at 60% brightness.
•
Touch the luminaire body (H) a third time, and the luminaire will light up at 100% brightness.
•
Touch the luminaire body (H) a fourth time, and the luminaire will turn off.
