1
LDT-3003
Installation and Operation
Instructions
The LDT-3003 combines a clock, hour meter, voltmeter, and up to three
temperature sensors in one housing. (Since the LDT-3003 is packed
with different options, you may not have all three temp sensors.) It
shows the temperature in either °F or °C, selectable by the user. This
unit fits in a standard 2 1/8" (54 mm) hole used by most marine equip-
ment manufacurers.
Mounting
The LDT-3003 mounts in any dash or flat panel that's at least 2 1/2" (64
mm) in diameter. To mount the unit, first make certain there is at least
3 3/4" (95 mm) from the
front
of the dash to any obstruction behind the
dash. Also, be sure there is room to route the power and sensor cables.
The
maximum
usable dash thichness is 1 1/8" (28.5 mm).
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
3 3/4" minimum
When you determine the location for the LDT-3003, drill a 2 1/8" (54
mm) hole in the dash. Slide the LDT-3003 through the hole from the
front of the dash. Align it so that it's straight, then tighten the two
screws with a phillips-head screwdriver.
Place the pushbuttons into the holes in the bezel and snap it on to the
LDT-3003. The unit is now ready for wiring.
DASH
TIGHTEN
THESE
SCREWS
