![background image](http://html1.mh-extra.com/html/lowes-0/3200-l/3200-l_installation-manual_1942659001.webp)
NOTE:
Each module outlet is rated to 12A only if the connecting cord is
rated at 90C or greater.
WARNING!
The total current limit of the device is 12A. Do not exceed this
value.
WARNING!
If a direct short is created on the output, the Smart Outlet will be
damaged and will no longer function.
WARNING!
If a load greater than 12 AMPs is attached to the output, the
Smart Outlet will be damaged and will no longer function.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
To utilize the repeater funcionality in Z-Wave-only mode, follow
these instructions:
1. When the device is first powered (or after a factory reset) it
will attempt to locate a ZigBee network. If none is available it
will then search for a Z-Wave network.
2. The user can also quickly include this device in a Z-Wave
network by double tapping the button during power up (after
a factory reset). This will start the join process for Z-Wave.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
∙ Reorient or relocate the receiving antenna.
∙ Increase the separation between the equipment and the receiver.
∙ Connect the equipment into an outlet different from that to which the receiver
is connected.
∙ Consult the dealer or an experienced radio/TV technician for help.
FCC Information
Z-Wave Setup
INSTALLATION GUIDE
LOWE’S IRIS SMART OUTLET
3200-L
Contains FCC ID:
W7Z-ZICM357SP2