Logan Graphic Products Inc. 1100 Brown Street, Wauconda, IL 60084 1-847-526-5515 1-800-331-6232
LoganGraphic.com
Adjustment Screw
Point Loading Cover
Point Depth Adjustment
Cover Release Button
Nose
Identification
N1329 1-15
Fig. 3
Fig. 2
3.
2.
1.
Fig. 4
3.
2.
1.
Fig. 1
Model F500-2
Dual DrivE Elite Point Driver
PICTURE FRAMING
Instruction Sheet
Operating Instructions
Loading Points
1. Press release button
2. Pull up cover
3. Install point strips with point facing
forward
NOTE:
Make sure points are inserted
down into nose piece.
4. Slide cover closed
(Fig. 1)
Operation
1. Hold outside of frame
2. Press driver nose against inside frame
3. Keep drive flat on material - DO NOT
LIFT OR ANGLE
4. Squeeze trigger to insert point
5. Space points 6” apart, 3” from corners
(Fig. 2)
Adjust Point Depth
1. Turn adjustment screw to increase
tension for hardwoods or decrease
tension for softwoods.
(Fig. 3)
Troubleshooting
IF GUN JAMS & NO LONGER FIRES POINTS
• Keep 1” or higher stack of points in gun at all times
• Make sure you are using authentic Logan rigid or flexible points (F53, F54, F55, F56).
• Make sure points are loaded and seated correctly. Try removing and re-loading the point strip.
• To remove a point jammed in the nose piece, reference the instructions to remove the nose piece, clear
it and re-install it.
• If point does not leave the gun, try reducing or tightening tension.
• Check to see that main body screws holding two halves of the tool together are not loose. If necessary,
re-tighten with Phillips screwdriver.
IF THE POINT BENDS
• If flexible inserts are bending or not staying in the wood, try increasing the tension or switch to rigid
points.
• Try reducing the tension if handle is hard to pull.
Point Jammed
1. Remove points
2. Remove nose screw and nut
3. Remove nose piece and discard
jammed point
(Fig. 4)
Replacement Points
Use only authentic Logan Points
F53 - Flex (600) F54 - Rigid (600)
F55 - Flex (2500) F56 - Rigid (2500)
Summary of Contents for F500-2
Page 4: ......
