The new Enforcer 140 LED handheld introduces Fresnel technology to the sporting market. The specially designed
lens produces a superior tight beam for maximum light output and performance. The internal battery has a run
time up to 4 hours and you can even attach the clip on Enforcer battery to produce an extended runtime of up to
18.5 hours. Combined with a lightweight ergonomic grip and an inbuilt battery indicator the new LED Enforcer 140
will provide the ultimate sporting experience.
RECOMMENDATIONS:
1. Replace rear protective seal on base of handle after charging to maintain IP rating.
2. Ensure all electrical connectors are secure - loose connections will generate excessive heat, damage wiring and
cause electrical failure.
3. The outer lens should be washed clean with copious amounts of water and a clean sponge. Wiping it with a dry
rag will scratch the lens, especially if the surface is dusty. NEVER clean the light with cleaning fluid or solvent.
4. DO NOT attempt to clean the inside of the light or touch the inside lens.
5. Never remove the reflector housing from the handle. The LED and lens inside are delicate and should never be
exposed to dust or handled.
6. Reflector housing should never be adjusted so two O-rings are visible, otherwise light will not maintain IP
rating.
BATTERY & CHARGING:
Charge the battery fully before first use.
Select required adaptor and fit on to mains charger.
Remove protective cover on base of handle and connect included universal AC mains charger’s DC plug in to DC
input on handle.
Connect AC charger to wall outlet.
The Enforcer LED 140 has a run time of 4 hours at 25°c. After this time, the light will enter ‘reserve’ mode,
allowing up to a further 1 hour at a reduced light output.
The Enforcer LED 140 can be charged via the supplied 100-240V universal AC to 12V DC charger or optional
Lightforce SLA and LiFePO4 battery packs as well as direct from vehicle.
The light can be operated while simultaneously being charged while connected to an external 12v DC supply.
Do not operate the light while charging from the AC wall charger.
The Enforcer LED 140 has an inbuilt charging circuit designed for 12v ONLY. Never connect the light to any power
source other than 12v.
The charge indicator in the base of the light will illuminate for 2 seconds once pressed.
If battery is to be stored for a long period of time, ensure battery has at least 50% charge.
The unit must be returned to a service agent for battery replacement.
SPECIFICATIONS:
490 grams / 17.28 ounces
IP65 ingress protected
IR LED: Wave length: 850nm
Red: 4hr runtime plus up to 1 hour of reserve mode @ 25 degrees
IR: 3 hours run time at maximum intensity
Maximum charge time being 2.5 hours
Red / IR Enforcer LED 140 Instructions
LIGHTFORCE AUSTRALIA PTY LTD • 11 Manton Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © AUGUST 2016 • Data and specifications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification.
INSTRUCTION DATA
PRODUCT:
RED / IR
ENFORCER LED 140
VER:
1.0
DATE:
AUGUST 2016
