RECESSED DOOR/WINDOW TRANSMITTER
Cat. No. 56A00-1
Installation Instructions
DI-022-HL561-05A
AR2253
(56I00-1)
WARNINGS AND CAUTIONS
• Read and understand all instructions. Follow all warnings and instructions marked on the
product.
• Do not use this product near water - e.g., near a tub, wash basin, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.
• Never push objects of any kind into this product through openings, as they may touch
dangerous voltages.
• Never install communications wiring or components during a lightning storm.
• Never install communications components in wet locations unless the components are
designed specifically for use in wet locations.
• Never touch uninsulated wires or terminals unless the wiring has been disconnected at the
network interface.
• Use caution when installing or modifying communications wiring or components.
• SAVE THESE INSTRUCTIONS.
The 56A00-1 Recessed Door/Window Transmitter is a supervised
wireless contact that can be concealed with a door or window frame
for virtual transparency. It works with the Leviton 45A00-1 Wireless
Receiver and is supplied with a replaceable lithium battery that lasts
for 5 years under normal operation.
OPENING THE 56A00-1
Use a flathead screw driver to open the 56A00-1 to change tops or
access the battery (See figure 1).
INSTALL BATTERY
Use care when installing the battery and observe the correct polarity when the
battery is inserted (See Figure 2). Use only Panasonic Lithium CR2 batteries
for replacement. When replacing battery use a flathead screw driver to open
the top (See Opening the 56A00-1).
WARNING! Battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
MOUNT TRANSMITTER AND MAGNET
It is important to select the proper placement of the recessed transmitter and
magnet. The transmitter has two separate tops that allow a flush mount or
screw mount in case you accidentally over drill the hole or require extra support to ensure the
transmitter does not move. The magnet does not have a second top with a flange to screw it
into place so you must be extra careful to ensure that the magnet is tightly in place
once installed.
WEB
VERSION
