Tynetec, a business unit of Legrand Electric Ltd
Cowley Road, Blyth Riverside Business Park, Blyth, Northumberland, NE24 5TF.
Tel: +44 (0) 1670 352371 www.tynetec.co.uk
Trusted Technology
Caring for People
869MHz Dual Smoke
& CO Transmitter
_________________________________________________________________________
________________________________________________________________
Doc No. FM0866 V1.03 Page 1
•
Fixed trigger device
•
Compatible with Reach IP, Advent XT2 & Carer Response
•
Transmitter housed in single gang surface pattress
•
2 normally open clean contact trigger inputs
•
80mm flying leads and screw connectors
•
Factory programmed with smoke & CO alarm codes
•
5 Year Lithium battery (typical)
•
Low battery warning
•
Operating Temperature: +5
o
C to +40
o
C
•
Telecare Transceiver: 869.2125MHz Class 1.5
•
Digital Heartbeat
•
Weight: 140 grams
•
Dimensions: 87mm x 87mm x 40mm (HxWxD)
•
Product Code: ZXT870
The dual transmitter can be connected to third-party
smoke and CO detectors to initiate an alarm call on an
Advent XT2 assisted living system, a Reach IP at-home
alarm unit or a Carer Response local Carer alarm.
The third-party detectors the transmitter is being
connected to must have momentary action, normally
open clean contact relay outputs that close on alarm.
The transmitter is factory programmed with smoke and
CO alarm AALRP radio codes.
Positioning
The boxed transmitter should be wall mounted in the
same dwelling as the smoke and CO detectors. The boxed
transmitter is suitable for indoor locations only.
Alarm Condition
When a third-party smoke or CO alarm is activated the
relevant alarm call type will be transmitted. A new alarm
will not be triggered until the detector has reset and is
activated again.
Low Battery Condition
A low battery condition will be reported automatically to
the Alarm Receiving Centre (ARC) or the local Manager.
The transmitter should be replaced as soon as possible
within 30 days. The transmitter can be returned to Tynetec
for battery replacement.
Out of Range Notification (Reach IP)
The Reach IP can monitor all radio peripheral devices to
determine whether they have been damaged or removed
from an installation. Should the Reach IP be unable to
detect a device’s heartbeat it will auto
matically generate a
“radio out of range” notification. Firstly
, investigate if
there’s a genuine reason for the alert, if not, arrange for
the peripheral device to be replaced immediately.
The “Radio
out of range t
imer” can be set from 30 hours to
99999
hours in Pulse CMP. “Radio
s
upervision” can be
disabled by unchecking the tick box associated with each
peripheral device in Pulse CMP.
Maintenance
Test the transmitter once every month.
Disposal
Waste electrical products should not be disposed
of with normal household waste. The unboxed
transmitter is ideally suited for disposal within
the waste electronic and electrical equipment
(WEEE) recycling scheme.
Please recycle where facilities exist.
Check with your local authority or contact your supplier for
recycling/disposal advice.
Warning
The transmitter contains a Lithium battery. If tampered
with the battery may be damaged and create a fire hazard.
No attempt should be made to remove or replace the
battery. Do not incinerate.
