915668-00 Rev A
MSO-MICTOR Instruction Sheet
Page 1 of 2
OVERVIEW
Included with the MSO-MICTOR cable shipment are the following:
•
Qty 1 - 36 channel Mictor cable
•
Qty 1 – MSO-MICTOR Instruction sheet (this document)
•
Qty 1 - Mictor Connector Shroud.
Note: Additional shrouds can be purchased in a 3 pack. The LeCroy part number is MSO-MICTOR-
SHROUD.
OPERATING ENVIRONMENT
Before using the MSO-MICTOR cable, ensure that its operating environment will be maintained within
these parameters:
Temperature:
5 to 40
o
C
Humidity: < 80% RH (non-condensing)
SAFETY REQUIREMENTS
CAUTION
To avoid personal injury or damage to the MSO-MICTOR or any equipment connected to it, review and
comply with the following safety precautions.
•
Use only as intended.
The MSO-MICTOR cable is intended to be used only with LeCroy MS-250,
MS-500 or MS-500-36 Mixed Signal Oscilloscope options. Use of the MSO-MICTOR and/or the
equipment it is connected to in a manner other than specified may impair the protection mechanisms.
•
Connect and disconnect properly
. Avoid damage to cables thru excessive bending. When
disconnecting the MSO-MICTOR cable from the MS-250, MS-500, MS-500-36 or Device Under Test
NEVER pull on the blue wires, pull only the black plastic housing.
•
For indoor use only.
The MSO-MICTOR cable and associated test equipment is intended for indoor
use and should be operated in a clean, dry, environment.
BASIC OPERATION
Connecting the MSO-MICTOR to the MS-500 or MS-500-36
•
Connect the end of the cable labeled D0 – D17 to the corresponding input of the MS-500 or MS-
500-36 labeled D0 – D17
and fasten thumb screws
•
Connect the end of the cable labeled D18 – D35 to the corresponding input of the MS-500 or MS-
500-36 labeled D18 – D35
and fasten thumb screws
Connecting the MSO-MICTOR to the Device Under Test
•
The MSO-MICTOR cable mates with the Tyco Electronics Pb free part# 2-5767004-2 Mictor
connector.
Looking into Mictor Connector:
Connector Pin #
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
3
D35 NC
D34 D33 D32 D31 D30 D29 D28 D27 D26 D25 D24 D23 D22 D21 D20 D19 D18
D17 Gnd D16 D15 D14 D13 D12 D11 D10 D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
Connector Pin #
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
3
8
7
www.
.com
1.800.561.8187
