4081R, 4084R, 4086R,
4087R, 4092
HAND TRUCKS
PLATFORM
SUPPORT
CLIP
HANDLE
CASTER
SMALL
LOCK NUT
LARGE
WASHER
AXLE
COTTER
KEY
LARGE
WASHER
AXLE PLATE
FRAME
Align holes in base of frame with square holes in foot plate.
Secure with carriage bolts, small washers and small lock
nuts as shown.
FOR 10-INCH WHEELS:
(Model No. 4084R and
No. 4086R) Slide axle through hole “A” in axle plates.
FOR 8-INCH WHEELS:
Slide axle through hole “B”
in axle plates.
NOTE:
If axle plate holes are too tight, scrape
excess paint from holes.
NEXT: Slide a large washer, a wheel (recessed side of
wheel hub facing out), and another large washer over
each end of axle.
Insert cotter key through each axle hole and spread
cotter key ends.
If not pre-installed, insert stem of caster
through hole (as shown) then fasten with
large lock nut.
For handle adjustment: line up any handle hole
to frame hole. “A” is standard, “B” is extended.
Use clip to lock in desired position. NOTE: insert
clip with exposed portion down.
For handle in platform position: remove handle
from frame assembly. Reposition handle in
platform supports and insert clips.
FOOT PLATE INSTALLATION
WHEEL INSTALLATION
CASTER, HANDLE INSTALLATION –
MODEL NO. 4086R AND NO. 4087R ONLY
AXLE PLATE HOLE “A”
AXLE PLATE HOLE “B”
“B”
“A”
CARRIAGE BOLTS
FOOT PLATE
FRAME
A S S E M B L Y INSTRUCTIONS
PRODUCT WARRANTY
is available online at:
www.safcoproducts.com
Safco Consumer Hot Line
1-800-664-0042
available Monday-Friday 7:30 AM to 5:00 PM (Central Time) (English-speaking operators)
SMALL
WASHER
LARGE LOCK
NUT
Minneapolis, MN 55428
www.safcoproducts.com
an LDI Spaces Company
Safco Products Company, New Hope, MN 55428
100408137: 1 of 3; Rev A; Rev Date 01-AUG-2016
