EPCS-PL-2X-RG
Larson Electronics, LLC
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
Explosion Proof Box Cover w/ Red & Green LED Pilot
Lights - Class I, II, III - NEMA
Instruction Manual
Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this
instruction sheet.
Read carefully before operating. Retain these instructions for future reference.
WARNING:
USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. IF PROPER INSTALLATION PROCEDURES ARE NOT
FOLLOWED EXACTLY, THE CONTROL STATION MAY NOT BE SUITABLE FOR THE HAZARDOUS LOCATION INVOLVED.
PERIODIC INSPECTION OF THE ENCLOSURE IS NECESSARY.
ALL LOCAL AND NATIONAL ELECTRICAL/BUILDING CODES MUST BE FOLLOWED WHEN INSTALLING THIS DEVICE. FOR CODE
INTERPRETATION, CONSULT YOUR LOCAL AUTHORITY. PRODUCT MUST BE USED ONLY WITH ALL CAP THREADS FULLY ENGAGED. DO
NOT USE IF DAMAGED.
CAUTION:
Before installing, make sure you are compliant with area classifications, failure to do so may result in bodily injury, death
and property damage. Do not attempt installation until you are familiar with the following procedures. All installation must
comply with the applicable Electrical Code.
Make sure that the circuit is de-energized before starting installation or maintenance.
Verify that the installation is grounded. Failure to ground will create electrical shock hazards, which can cause serious
injury and or death.
IMPORTANT:
Please read these instructions carefully before installing or maintaining this equipment. Good electrical practices should
be followed at all times and this data should be used as a guide only.
Technical information, advice and recommendations contained in these documents is based upon information that
Larson
Electronics
believes to be reliable. All the information and advice contained in these documents is intended for use only
by persons having been trained and possessing the requisite skill and know-how and to be used by such persons only at
their own discretion and risk. The nature of these instructions is informative only and does not cover all of the details,
variations or combinations in which this equipment may be used, its storage, delivery, installation, check out, safe
operation and maintenance. Since conditions of use of the product are outside of the care, custody and control of
Larson
Electronics
, the purchaser should determine the suitability of the product for his intended use, and assumes all risk
and liability whatsoever in connection therewith.
INSTALLATION
We strongly recommend that only a licensed electrician install this product.
This Explosion Proof Control Station comes preconfigured from factory with
two
pilot lights colored Red.
WARNING:
Mis-wiring could cause permanent damage.
DO NOT
connect with power applied.
1.
Choose a suitable location to mount the control station where conduit can reach the box.
3/8”-16 or 3/8”-24 bolts
are recommended for mounting the box with a minimum bolt length
of ¼” depending on the location.
2.
Run control wire to box following appropriate methods via conduit.
3.
Wire according to the wire diagram visible on each device.
After wiring each system, secure the enclosure and enable the circuit to test each system.
NOTE:
All installations must comply with applicable local and/or National Electrical Code
CAUTION:
Disconnect this device from the supplying circuit before entering. Keep assembly tight while circuits are alive.
Pilot Light:
120 V AC, 250 V AC, 12
V AC/DC
, or 24 V AC/DC
Phone:
877-348-9680
