7b. If your kit includes a double foot
labeled (DL), connect as seen above.
Frame on right (shown in gree
above) attaches to the front foot
nub and overlaps the back frame by
approximately 3.5 inches.
2. Connect poles to corners.
(See diagram to on next page)
1. Straighten and assemble all
bungeed poles.
4. Lay frames down. Pull pillowcased
graphic over frame and zip closed.
6. Stand frames up.
Note: This step is easier with two people.
5. Clamp optional lights on top bar.
Tip: Put lights on before standing the display up.
Companion II Display
General Assembly Instructions
Updated 10/16/2014
Note: Assembly is the same for all shapes and sizes of Elements Frames
7c. If your kit includes a double foot
labeled (DR), connect as seen above.
Frame on left (shown in green
above) attaches to the front foot
nub and overlaps the back frame by
approximately 3.5 inches.
7a. Attach feet to bottom of frames.
Secure foot with locking pin.
3.
If your kit includes a center
support pole, insert it into the
corresponding holes, located in the
top and bottom poles of the frame.
Frames over 100” wide recquire support poles
DL
DR
