Australian datasheet only
– June 2014
Bona PowerDrive
Bona PowerDrive is a unique drive plate with four driven sanding discs for
unsurpassed powerful rotary sanding of timber floors. Mounted on the Bona FlexiSand
1.5 or 1.9, it is capable of removing thick layers of varnish and can be used for the full
renovation of wooden floors, replacing the need for conventional belt sanding in many
instances. The advantages of rotary sanding is the simplicity of use and minimized
need for edge sanding while delivering excellent sanding results. The drive plate is
easy to manoeuvre in small, confined spaces and can be used independent of the
direction of the wood.
For powerful rotary sanding to bare wood
Reduces need for edge sanding. Only leaves a 3 cm strip against the wall.
Delivers a fine and smooth sanding result
Failsafe; no risk of drum marks and similar
Can, through the FlexiSand 1.5 or 1.9, be connected to Bona DCS 70 for dust free
sanding.
Compatible with: Bona FlexiSand 1.5 & 1.9
No. of discs: 4
Disc diameter: 150 mm
Weight: 6.7 kg
Dimensions: 410 mm / 410 mm / 93mm
The Bona PowerDrive can
only
be used with the Bona FlexiSand 1.5 or 1.9.
Disconnect the machine before attaching or removing the PowerDrive.
Attaching the PowerDrive
1. Place the cog ring against the chassis and align it with the screw holes.
2. Fasten the cog ring with the supplied self-cutting screws.
3. Push the drive plate towards the machines driving axle so that the cogs meet
the cogged ring.
4. Turn one of the sanding discs clockwise until the drive plate can be locked.
5. Secure the drive plate by folding down the latch bolt.
Removing the PowerDrive
1. Lift the latch bolt
2. Place the tip of the supplied box spanner between the driving axle and the
drive plate bracket and then push against the drive plate.
3. Turn one of the sanding discs counter clockwise until the drive plate can be
freed.
Carefully read through the entire user manual and the safety instructions for the
Bona FlexiSand 1.5 / 1.9 before using this equipment. To obtain the best, dust free
result, use the Bona DCS 70 with the Bona PowerDrive, although other suitable
vacuum systems may be used
Before you start the FlexiSand 1.5 / 1.9, lower the handles to a comfortable working
position
– release the handle lock by pressing the silver button in the top of the handle.
When using the PowerDrive the handles should be held at approximately chest height
and not taken down to waist height as is normal with other work using a buffing
machine. Start the machine by pressing in one of the small red control buttons and
gripping the red triggers on each side of the machine handle.
Assembly
Directions for use
Technical data
Phone 1300 882 806
