Tel:
+44 (0)1274 657 088
Fax:
+44 (0)1274 657 087
Web:
www.cromptonlamps.com
Images are for information only. Phoebe LED shall not be held liable for improper operation of the luminaire
in circumstances where procedures and specifications have not been followed correctly. Crompton Lamps Limited 2020
300mm
294mm
82mm
Environmental Protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
THANK YOU for buying this PHOEBE LED product.
To help ensure this luminaire gives complete satisfaction please only use it according to the
following instructions, and then pass the instructions to the appropriate person for retention and future reference.
This instruction sheet is relevant to Phoebe LED KRIOS Emergency Twin Spot
product code: 13995
Warning
1. Installation only to be carried out by a qualified electrician
2. Please ensure mounting surface is suitable
3. Do not operate if product is damaged
4. IP65 suitable for wet weather outdoor use
Product
code
Description
Power
(W)
Colour
13995
Krios Twin Spot
2.3
6000K Daylight
1
a.
Switch off power at circuit.
b.
Remove the front panel from
the body by removing the four
corner fixing screws.
c.
Take out the fixings bag from
the inside of the unit.
BEFORE YOU START
PLEASE READ ALL THE
INSTRUCTIONS CAREFULLY
ONLY ONCE INSTALLATION
IS COMPLETE
Turn power
back on at
the mains
CIRCUIT TESTING
For high voltage circuit insulation
testing disconnect mains input
supply first
(Do not circuit test using a Megger)
Turn power
off at the
mains
PRIOR TO INSTALLATION
2
a.
Drill out the intended cable
Ø20mm entry hole suitable for
your installation.
b.
Secure the luminaire to the
mounting surface at the Ø4mm
screw points indicated using the
supplied self tapping screws.
to
mains
240V
4
a.
Connect to mains power in accordance
with current wiring regulations, the mains
connector is located on the lower right of
the circuitboard (see wiring diagram).
b.
Mark installation date on battery and
connect battery cable.
Wiring Diagram
5
a.
Refit the front panel to the body with the
screws from part 1b.
b.
Switch on the power at circuit.
3
a.
Fit the waterproof connector to
the entry point and pass the mains
supply into the luminaire.
b.
Pass the mains cable through the
cable retention bracket and tighten.
c.
Wire the luminaire to mains in
accordance with current wiring
regulations, the mains connector
is located on the lower right of the
circuitboard.
Viewing
Distance
(b)
(a)
(a)
(b)
(b)
(b)
(b)
(a)
(b)
To 240V Mains
(a)
AC INPUT
(b)
(b)
