Titan 8 Person Tent
KDTNT8PTTNA
Quick Start Guide
Safety Warnings
This tent has been developed and is intended to provide shelter from sun and light rain. It is not intended
for use during heavy rain, wind, hail or snow.
The tent should be dismantled when not in use.
Do not use any gas or flame sources under, inside or near this product.
Under no circumstances should this product be used as a permanent or temporary storage facility.
This product meets the flammability requirements of CPAI-84. This product is not fire proof. The fabric may
burn if left in continuous contact with any flame source.
Never use devices that produce fumes, including stoves, lanterns, candles or heaters in or around this tent.
Assembly
Step 1
: open the inner tent and lay
it out flat on the ground.
Step 2
: Separate the steel tubes
into their sizes. The tubes with the
red marks are the short tubes.
Also lay out the 4 segmented
fibreglass poles.
Step 3
: Slide the fibreglass poles
into the inserts within the inner
fabric sheets.
Step 4
: Please insert the
segmented fibreglass poles into
the steel tubes. (The tube shown
on the left is the short tube. The
tube shown on the right is the
long tube.)
Step 5
: Attach the poles to all four
segmented poles. Ensure that the
short steel tubes are attached to
the poles at the ends of the tent,
and the long tubes are attached
to the poles in the middle of the
tent.
Step 6
: Locate the steel ring pin
on the pink straps and insert the
pins into the holes at the ends of
the short steel tubes (which have
the red markings on them).
