Installation Guide
3/8"
Bucket
1
For Three-Hole Sinks:
Assemble as shown.
Important Information
For new installations, assemble the
faucet to the sink before installing the
sink.
Observe all local codes.
Shut off the water supply.
CAUTION:
Risk of fresh water
contamination.
This faucet contains back-siphonage
protection.
To prevent water
contamination, do not remove any
internal components from this faucet.
Record your model number below
for future reference:
3-Hole Only
3 orifices seulement
3 orificios solamente
Plastic
Plastique
Plástico
Metal
Métal
Metal
4
Slide the washers onto the shank
and thread the ring onto the
shank.
1/4" (6 mm)
3
Partially thread the screws into the
ring until they extend 1/4” (6 mm)
out the opposite side.
2
For Single-Hole Sinks:
Install the faucet.
For Three-Hole Sinks:
Install the
nuts on the studs and handtighten
securely.
For Three-Hole Sinks:
Install the
faucet.
9
Align the spray hose with the
outlet tube and click together.
8
Attach the weight to the spray
hose.
7
Turn on the water supplies. Flush
the hot and cold water for 1
minute.
6
Connect and tighten the supply
hoses.
1/4"
(6 mm)
5
Position the screws on the ring
to the front and back. Tighten the
screws.
14
Install then fill the soap bottle.
13
Install the soap dispenser
escutcheon.
12
Adjust the weight as needed for
proper positioning and operation.
11
Check for smooth operation.
2" (51 mm) –
3" (76 mm)
10
Position the weight on the spray
hose as shown.
1241700-2-
B
