Assembly Instructions
Footprint
®
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741536
Revision C-08
Page 1 of 6
Square and Radius Profile
Undersurface Storage
Tools Required
■
Level
■
Electric Drill with Phillips Bit
■
Tape Measure or Ruler
■
3
⁄
16
" Nut Driver or Socket
Package Contents
■
Undersurface Unit
■
Plastic Glide Hole Plugs
■
#8 x
3
⁄
4
" Panhead
(hinged door and open
Phillips Wood Screws
bookcase units only)
Installation
Note:
These instructions provide the basic information
for installing Footprint radius and square profile
undersurface storage units. (Figure A). The tops of the
undersurface units are pre-drilled. Worksurfaces are
NOT
pre-drilled. Installation of radius profile and square profile
units is similar except for the amount of recess from the edge
of the worksurface outlined in Step 2.
Figure A
Square Profile
(File/File shown)
Radius Profile
(File/File shown)
Figure B:
Box Drawer
Suspension
“A”
“B”
1. Remove all drawers from undersurface storage unit.
Kimball Office utilizes three types of drawer suspension
systems: box drawer suspension, file drawer suspension
and lateral file drawer suspension. Follow the steps below
to properly remove both types of drawers.
Box Drawer Removal (Figure B)
■
Pull the drawer to fully opened position.
■
Remove the shipping screw “A” from both left and right
metal suspensions.
■
Simultaneously press the nylon release tabs “B” inward
towards the drawer and lift the drawer off slides.
File Drawer Removal (Figure C)
■
Extend the file drawer to its full extension.
■
Locate the drawer slide release tab, in the approximate
location shown, on each side of the drawer.
■
Press tabs in and pull drawer straight out until slide
drawer members disengage from cabinet members.
Figure C:
File Drawer
Suspension
Release Tab
Lateral File Drawer Removal (Figure D)
■
Pull the drawer to fully opened position.
■
Remove the shipping screw “A” from both left and right
metal suspensions.
■
Simultaneously press the nylon release tabs “B” inward
towards the drawer and lift the drawer off slides.
“B”
“A”
Figure D:
Lateral File Drawer
Suspension
