![background image](http://html1.mh-extra.com/html/kim-lighting/micro-flood/micro-flood_installation-instructions_1967182001.webp)
Part No. 95500
8/30/13 EC 130822022 Status 17
Micro-Flood
®
Installation Instructions
Make certain electrical supply is OFF before starting fixture installation.
!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical
Code. Portable spear mounts using a cord and plug must be plugged into a receptacle protected by
a Ground Fault Circuit Interrupter in accordance with the National Electrical Code. Failure to do so
may result in serious personal injury. DO NOT operate luminaire with missing or damaged lens.
SAFETY WARNING: Fixtures can become very hot depending on the lamp wattage used. Glass
lenses and metal areas above and around the lamp can become hot enough to blister hands.
Particular care should be taken not to locate fixtures where small children can reach them if higher
wattages are used.
CAUTION: When relamping fixture avoid touching the lamp envelope with bare hands. Lighted lamp is HOT!
If touching the lamp is necessary during installation, clean the envelope with alcohol and dry with a clean,
soft cloth before burning. Contamination of the quartz envelope may reduce lamp performance. Fixtures
are approved for above ground installation only.
NOTE: Keep the lamp free from impact while burning, as this may deform the filament and shorten life for
Halogen/Metal Halide lamps
KEEP THIS SHEET FOR FUTURE REFERENCE.
!
!
EL215
16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
Tools Required:
q
F"
Allen Wrench
q
B"
Allen Wrench
q
Phillips Head Screwdriver
q
Flat Head Screwdriver
q
Adjustable Wrench
q
Thread Sealant
2
. Coat coupling threads with
a good sealant and tighten
coupling onto mounting
device*. Re-tighten set screw.
1
. Loosen set screw at bottom
of mounting device* with
Phillips Head screwdriver.
3
. Install fixture onto coupling
and attach fixture leads
observing polarity …
4.
white-to-common, black-
to-voltage. Screw on Junction
box cover, making sure gasket
is securely in place.
*Consult KIM Landscape Lighting Collection Catalog for mounting device options.