BATTERY REQUIREMENTS:
NO. 84541
CONTENT
S
Nano Vortex Stunt RC Vehicle
Radio Transmitter & Antenna
Main body
Abrasion Resistance
Left Stick
- Controls Forward /
Reverse speed on
left side wheels of
Nano Vortex
Right Stick
- Controls Forward /
Reverse speed on
right side wheels of
Nano Vortex
Antenna
Power On LED
On / Off Switch
1. Vehicle:
Built in 1 x 3.7V Lithium Ion
(Included)
2. Transmitter:
2 x AAA battery (Included)
3.7V
3.7V
Rechargeable Battery Must Be
Recycled Or Disposed Of Properly.
Battery
Pack
Rechargeable
Rechargeable
1. Do not drive on grass, dirt, sand, dusts, carpet or go through water.
2. Do not drive in windy or rainy weather.
3. Avoid direct impact the Vehicle with obstacles.
4. Switch OFF the power when not in use to prevent damage of Vehicle and
Transmitter due to leakage of electrolyte from batteries.
5. Remove all batteries from the Vehicle and Transmitter when not in use for
long period.
6. Keep fingers, hair and loose clothing away from wheels.
7. The operating range can be affected by a variety of factors a) Low
Voltage of batteries in Transmitter or Vehicle b) Interference from other
items that emit radio frequency signals.
8. Outdoor usage is recommended in order to get optimum control range.
9. Recommend to play the vehicle on a clean and smooth surface.
10. Clean the battery compartment to make sure it is free from dust to
prevent poor contact of batteries
You can operate your Nano Vortex indoors or outdoors.
The Nano Vortex is designed to
operate in most rugged conditions and terrains. Do not operate your Nano Vortex on roads or any areas where there are cars.
Operating your Nano Vortex on roads or any areas with cars is extremely dangerous and most likely illegal! The Nano Vortex is
not water resistant. Do not operate your Nano Vortex in any wet conditions, mud, puddles, rain or any other form of precipitation
or harsh weather. The Nano Vortex has open Cooling Vents in some strategic locations. If water gets into these Cooling Vents, the
Nano Vortex could sustain damage. If operating your Nano Vortex indoors, be careful to avoid contact with any objects such as
furniture, plants, electronics, and any other items which can break easily. The Nano Vortex is capable of some relatively high
speed stunts and could easily damage some household objects. Avoid operating your Nano Vortex around pets or people, and
especially crowds. If the Nano Vortex is stepped on or otherwise crushed, it will sustain damage. Ensure that people around you
are aware that you are playing with your Nano Vortex. Be aware of changes in your operational environment and play safe! The
radio control range of your Nano Vortex is up to 40M, and varies depending on interference within the operational environment.
WARNING: The relatively high speed stunts of the Nano Vortex are capable of damaging or injuring plants, furniture, pets or
people so play carefully.
Performance Tips
The packaging and instruction manual contain important
information. Please keep them for future reference.
Warning! Choking Hazard. Not suitable for children under
the age of 3 years due to small parts.
We reserve the right to improve/amend specifications and
colors without notice.
CHOOSING YOUR PLAYING LOCATION
CAUTION
Charging the Rechargeable Battery Pack for the Vehicle
• Be Sure To Charge Battery Pack Before Using.
• If Battery Pack Is Hot After Use, Allow To Cool Before Recharging.
• Do Not Dispose Of Battery Pack In Fire.
• Do Not Recharge Battery Pack That Shows Leakage Or Corrosion, Or Attempt To Open Battery Pack.
1. Connect the 3.7V rechargeable battery pack to the battery charger via the USB adapter charger.
2. Plug the charger into the standard AC socket.
3. The charging time for a full charge is about 30 mins.
4. When charging is completed, unplug the charger from the AC socket.
5. Disconnect the rechargeable battery pack form the battery charger and the USB cable.
CON
TEN
TS
USB Adapter Cable
Built in Battery
INSTRUCTION
MANUAL
(Included)
USB
Cable Adapter
2 x AAA
For Transmitter
(Included)
Built in
1 x 3.7V
(250 mAh)
Lithium Ion
battery
(Included)
Conforms to the safety requirements of ASTM F963
kidztech toys
6
1/40
SCALE
Cautions
1. Do not attempt to disassemble the Vehicle or Transmitter.
2. Make sure the batteries are installed with correct polarities (+/-) as shown
inside the battery compartment.
3. Remove the package and take out all accessories before giving the Vehicle and
Transmitter to child to play.
FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
RSS
210 Compliance Statement:
This device complies with Industry Canada licence-exempt RSS
210. Opera
tion is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada,. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Declaration of Conformity
The product is in conformity with the requirement of EU Directive 2014/53/EU.
Environmental notes:
The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.
Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful
substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury
FPO
FPO
FPO
FPO
