www. kenall.com P: 800-4-Kenall F: 847-360-1781 1020 Lakeside Drive Gurnee, Illinois 60031
1
INSTALLATION INSTRUCTIONS
MLAS826_MLAS826-LED-040113
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH
ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT
TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS
AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE
FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1. Remove the screw(s) from the luminaire
and unhook front housing (B) from the
baseplate assembly (C).
2. Remove the reflector / wireway to expose the
mounting holes.
NOTE: The luminaires with the lamp options, F55TT Biax
and F24T5HO, will have the ballast fastened to the wire
way and are grounded to the baseplate with a quick
disconnect.
3. Remove 1.50" knockout in the center of the
baseplate (C).
MLAS SERIES
MILLENIUM AURACYL
™
SCONCE
Screw and Housing Removal
4. Use the baseplate (C) as a template and mark the
pilot holes (E) on the mount surface. Orient the
baseplate (C) with the angle bracket hook (D) at
the top.
5. To ensure wet location rating, apply square
gasket (supplied) around wire access opening and
six round gaskets (supplied) on the wall side of
the baseplate.
6. Using 1/4-20 fasteners and anchors appropriate
for the mounting surface (not supplied), mount
fixture base.
7. Disconnect facility power to the electric power
supply leads.
