![background image](http://html.mh-extra.com/html/kelkay/easy-fountain-4626l/easy-fountain-4626l_instructions_662176001.webp)
Easy Fountain Instructions
4626L Elegance Fountain
STAGE 1
Position the water feature onto a secure and level location.
STAGE 2
STAGE 3
STAGE 4
STAGE 5
STAGE 6
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
Push the cable with 2 pins into the safety isolating transformer and screw over the plastic collar to
secure it into place.
Carefully fill the fountain with sufficient water to fully submerge the pump.
ELECTRICAL SAFETY:
If outdoors the outlet
must be waterproof. We recommend the use of a
residual current device (GFI) Ground Fault
Interrupter (available from all good D.I.Y. stores)
when connecting the fountain to the electric
supply.
PUMP FLOW:
The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
Push the LED cable into the wire which extends from the pump and screw over the plastic collar to
secure it into place. Attach the internal water pipe onto the pump outlet.
Following the diagram above, reach inside the access cavity to locate the water pipe and the
internal LED cable and carefully bring these out of the water feature as illustrated above.
Connect the plug from the transformer to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
www.kelkay.com