background image

KD-G464

Installation/Connection Manual

GET0302-002A

[UI]

1204DTSMDTJEIN
EN

This receiver is designed to operate on 

12 V DC, NEGATIVE ground electrical systems

. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC 

car audio dealers.

J

Handles

F

Washer (ø5)

G

Lock nut (M5)

H

Mounting bolt (M5 x 20 mm)

I

Rubber cushion

A

 / 

B

Hard case/Control panel

D

Trim plate

E

Power cord

Parts list for installation and connection

The following parts are provided for this receiver. 
After checking them, please set them correctly.

1

INSTALLATION (IN-DASH MOUNTING)

The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
•  If you are not sure how to install this receiver correctly, have it installed by a qualifi ed technician.

Do the required electrical connections.

*

When you stand the receiver, be 
careful not to damage the fuse on 
the rear.

Bend the appropriate tabs to hold 
the sleeve fi rmly in place.

TROUBLESHOOTING

• 

The fuse blows.

*  Are the red and black leads connected correctly?

• 

Power cannot be turned on.

*  Is the yellow lead connected?

• 

No sound from the speakers.

*  Is the speaker output lead short-circuited?

• 

Sound is distorted.

*  Is the speaker output lead grounded?
*  Are the “–” terminals of L and R speakers grounded in common?

• 

Noise interfere with sounds.

*  Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

• 

Receiver becomes hot.

*  Is the speaker output lead grounded?
*  Are the “–” terminals of L and R speakers grounded in common?

• 

This receiver does not work at all.

*  Have you reset your receiver?

C

Sleeve

K

Battery

L

Remote controller

Removing the receiver

Before removing the receiver, release the rear section.

Insert the two handles, 
then pull them as illustrated 
so that the receiver can be 
removed.

When installing the receiver without using the sleeve

In a Toyota for example, fi rst remove the car radio and install the receiver in its 
place.

When using the optional stay

Note : 

When installing the receiver on the mounting bracket, make sure 
to use the 8 mm-long screws. If longer screws are used, they could 
damage the receiver.

Bracket*

Bracket*

*  Not included for this receiver.

Flat type screws 
(M5 x 8 mm)*

Pocket

Flat type screws 
(M5 x 8 mm)*

Screw (option)

Stay (option)

Fire wall

Dashboard

Install the receiver at an 
angle of less than 30˚.

PRECAUTIONS on power supply and speaker connections:

• 

DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the receiver will be seriously 
damaged.

•  BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

RM-RK50

Instal1-2_KD-G464_002A_1.indd   1

Instal1-2_KD-G464_002A_1.indd   1

12/22/04   11:35:47 PM

12/22/04   11:35:47 PM

Reviews: