Portable BACnet/IP to MS/TP Router
Installation Instructions
Applications
The Portable BACnet
®
/Internet Protocol to MS/TP Router (TL-BRTRP-0) routes information between
BACnet/IP and MS/TP networks. It is intended to be used as an interface between the following
applications:
• Controller Configuration Tool (CCT) software (running on your computer) and
Metasys
®
BACnet
Controllers (CGMs, CVMs, FACs, FECs, and VMAs)
• FX CommPro BACnet software (running on your computer) and Facility Explorer
®
(FX) Controllers
fitted with BACnet MS/TP communication cards
Note:
CCT must be at Release 5.3 or later to support the BACnet routing connection.
To configure the BACnet/IP to MS/TP router, use the router webpage.
The router electronics exist in a small portable case and are powered from the computer USB port;
however, no USB drivers are needed. The router contains a 10/100 Mbps Ethernet Auto-Medium
Dependent Interface Crossover (MDIX) port and an MS/TP compatible port.
The MS/TP port offers a choice of EIA-485 connectors (an RJ-11 connector or a 3-pin terminal block
with removable plug) and is optically isolated from USB power. The MS/TP port can support 127
devices. The MS/TP port also supports up to 32 devices on a single segment, and you can use
repeaters to add additional devices or to extend bus length. All MS/TP baud rates are supported.
Installation
Parts included
Included in this package are the following items:
• BACnet/IP to MS/TP Router
•
Portable BACnet/IP to MS/TP Router Installation Guide (Part No. 24-10414-2)
• USB cable
• CAT5 Ethernet cable
(barcode for factory use only)
TL-BRTRP-0
*24104142G*
Part No. 24-10414-2 Rev. G
2019-07-16
Summary of Contents for TL-BRTRP-0
Page 10: ...www johnsoncontrols com ...
