Installation Instructions
LC-200S
1
ISTISJCELC200S 0.0
2012/19/EU
LC-200S
IR DETECTOR
1. INTRODUCTION
LC-200S is the detector for all security installations needing an excellent product that is easy to install, suitable for any residential installation and does not
require special attention for programming. No special care is required for the detector. It can simply be installed and turned on.
LC-200S detectors are equipped with lenses designed by Johnson Controls and are manufactured by Fresnel Technologies, Inc.
LODIFF
®
optic creation technology combined with POLY IR
®
materials make it a product of the highest quality and efficiency.
LC-200S detector is pet immune (feature not evaluated by UL/ULC) and has a 12 m (40 ft) range at a 100-degree angle.
2. INSTALLATION
- Using a thin screwdriver, loosen the bottom screw and open the cover (see Fig 1)
- Remove the board from the base by levering the ABS cover (see Fig 2)
- Drill the stopper on the base of the cover at the desired fastening location (or use the optional swivel that is not IMQ certified)
- Recommended height is 2.1 m
- Slide the cable in through the back slot and out the top hole
- Wire the terminals following the connections shown in “Connection and Setup”
- Fig 1 -
- Fig 2 -
Ultraviolet Stabilization
POLY IR
®
4 Lens Material
The lens is printed with POLY IR
®
material.
This materials offers a better combination of
transmittance, environmental stability and color
than any other polymer on the market. Materials
are available for the 8-14 micron infrared region.
LODIFF
®
and POLY IR
®
are registered trademarks of
Fresnel Technologies, Inc.
LODIFF
®
Fresnel Lens Technology
This lens series is made by tiling LODIFF
®
lens pieces.
These lenses offer significantly improved performance
over the typical constant-bandwidth Fresnel lens.
LODIFF
®
and POLY IR
®
are registered trademarks of
Fresnel Technologies, Inc.
High RFI Protection
The detector has very high RFI immunity due to
the complete lack of traditional amplifiers.
White Light Protection
The detector digitally filters white light
components.
Pet Immunity
Thanks to a new lens design and the digital analysis
system, all of our detectors are immune to pets
weighing up to 15 kg.
Digital Signal Analysis
This detector is equipped with a traditional PIR with
a processor that converts the analysis into digital
format for optimum performance in all situations.
NOTE: Do not partially or completely cover the detector's field of vision
NOTE: the pet function is not IMQ certified
PULSE
jumper
LED
jumper
T-A-EOL
jumpers
