INSTALLATION INSTRUCTIONS
L516L – PULSAR L
Technical Support
855-592-0029
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 0
5/22/2015
Page 1 of 2
Read and understand these instructions before installation
This product is intended for installation in accordance with the National Electric Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before installation.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
No consumer serviceable parts. Contact factory if service is required.
For use in dry locations only.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR ATTACHING LUMINAIRE TO
TRACK
1.
Disengage LOCKING TAB by pulling it downward.
2.
With LOCKING TAB disengaged, rotate the
luminaire 90˚ clockwise until it is in position.
3.
Release LOCKING TAB, make certain it is locked.
INSTRUCTIONS FOR REMOVING LUMINAIRE
FROM TRACK
1.
Disengage LOCKING TAB by pulling it downward.
2.
With LOCKING TAB disengaged, rotate the
luminaire 90˚ counterclockwise and then remove.
NOTE
See below for system specific orientation.
Consult factory for compatibility to other
manufacturer’s track system.
If you encounter resistance when rotating the
adaptor, check orientation of adaptor to track.
CAUTION
RISK OF ELECTRICAL SHOCK
DAMAGE TO TRACK AND ADAPTOR IF ORIENTATION IS INCORRECT
H Series
L Series
J Series
