The following steps describe downloading a new firmware into your iTHX iServer product.
1.
If the model of your iServer is iTHX-W, iTHX -M or iTHX-2, open the enclosure to
access the PCB board (
see Figure 1
).
Figure 1a Opening Unit iTHX-W Figure 1b Opening Unit iTHX-M
Figure 1c Opening Unit iTHX-2
1
ON
FRONT BEZEL
MOUNTING
HOLE & POST
CASE SIDE
MOUNTING
HOLE & POST
4 SCREWS
PULL SIDES
APART AT REAR
REMOVE 2 SCREWS
AND PULL COVER OFF
T
O
OPEN
FIRMWARE UPGRADE INSTRUCTIONS
REMOVE 2 SCREWS
AND PULL COVER OFF
JTAG
T
O OPEN
