The
WaterGraph Data Shuttle (900-DS) is a device that downloads collected data
from either 900M or 950R series WATERMARK Monitors and stores the
data on a multimedia card (MMC). The card can be removed
from the
Data Shuttle, inserted in to a reading device
connected to a PC, then read by
WaterGraph
software for analysis of the recorded data.
Operation
The Monitor should be asleep with no
information on the display before proceeding. If
necessary, wait 30 seconds for the unit to return
to sleep mode.
Downloading from the Monitor will not
delete data from the Monitor by default. If
deleting data is desired, an option can be set on
the device. Refer to the software instructions on
page 4 for information on setting this parameter.
To collect data from a Monitor:
1. Connect the supplied cable from the
Data Shuttle to the shuttle port on the
Monitor.
2. Press the green button on the
Data Shuttle. The green LED should light, and
begin flashing as the data is downloaded.
3. When the download is complete the LED will go out, followed by an audible beep.
4. Disconnect the cable. The
Data Shuttle is now ready to download other
Monitors.
5. When all downloading is complete, use
WaterGraph software to import
collected data.
The
Data Shuttle is supplied with a multimedia card (MMC) and reading device.
To install the reading device, simply plug it in to an open USB port on your PC. The
PC will automatically detect and install the device. Once installed, cards installed in
the reader will be accessible as drives in “Computer” or “My Computer” in your
D
ATA
S
HUTTLE
INSTALLATION AND OPERATING INSTRUCTIONS
1
