Troubleshooting the iBeLink DM22G Blade
11/18/2017 Rev1.1 Fixed steps for Section I.
This guide will help you to troubleshoot and fix some common issues that can occur on the
iBeLink DM22G Blades. The three most common issues that can occur are the following: Blade
not being detected, not detecting all chips on a Blade, and displaying a high H/W reading.
I.
Blade not Detected
The first thing to check is for a conductivity issue.
1.
Remove the black and steel metal bar that is across the top of the blades. They are
held in place by 6 screws. See picture below.
2.
Remove the 4 screws attaching the Blade to the case.
Summary of Contents for DM22G Blade
