120-333E2
|
1
Note
If converting to natural gas, order the Natural Gas Conversion Parts kit (P-1200) from your authorized
IBC distributor.
Use the Propane Gas Conversion kit if the fuel source at the site uses propane and the modulating boiler has
been set up (factory fire-tested) to operate with natural gas. Check the rating plate on the boiler to see which fuel
source the particular boiler has been set up with.
Using this conversion kit, a qualified technician will need to:
1. Perform a fuel conversion.
2. Perform a combustion test.
3. Fill in the information required on the fuel conversion labels, and affix them to the boiler after the
conversion is completed.
Warning
This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer’s instructions and all applicable codes and requirements of the authority having
jurisdiction. If the information in these instructions is not followed exactly, a fire, an explosion or
production of carbon monoxide may result causing property damage, personal injury or loss of life.
The qualified service agency is responsible for the proper installation of this kit. The installation is not
proper and complete until the operation of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
Included with the Conversion Kit:
Fuel Conversion Kit, NG to LP - EX 700
Part #
Description
Quantity
150-001
O-Ring, 126 Nitrile
1
150-025
Wshr, Flat, Zn, 1/4
4
150-159
M5 Flat Washer
4
150-329
M8 x 14 Hex Bolt
6
150-339
M8 Flat Washer
6
150-354
M5 x 25 Hex Bolt
4
150-373
Hex Bolt 1/4-20 x 1.25L
4
150-376
O-ring
1
180-255
Mixer, PGT700, LP
1
080-284
Rating plate overlay
1
080-244
Installer identifier label
1
080-107
Gas valve conversion label
1
EX 700 - Fuel Conversion to Propane
(NG to LP) - P-1201
