Before calling service, check the following points for
possible misuse.
If you can't correct the problem after going through
this chart, contact a service professional for further
assistance.
1. Manual iris lens
2. Auto iris lens
1) Before mounting a lens, please check whether
it is a C mount or CS mount lens.
2) CS mount lens : After removing the protective
rubber, attach the lens.
3) C mount lens : Before installing the lens, attach
the C mount ring to the camera.
4) Set the LENS mode to "manual" by OSD.
1) Attach a DC lens as like the manual lens connection.
2) Connect the lens plug to the auto iris lens connector
on the rear panel of the camera.
3) Set the LENS mode to DC and adjust DC level
by OSD.
※
The lens is not supplied with this camera.
1. This camera supports supreme resolution(650TVL).
1. Do not install the camera outdoors.
Use weatherproof housing for outdoor.
2. Choose an ideal location for the camera, since the
camera unit must be protected against moisture
and vibration.
3. Be careful not to scratch the camera unit, especially
lens glass.
4. Use the camera under proper temperature.
(-10°
C ~ +50°
C)
5. Handle with care. Dropping it can cause serious
damage to the camera.
6. Avoid any direct sun light into the lens.
7. Use the adaptor regulated 12V DC, 300mA.
1. Remove the protective rubber before installing a
CS mount lens.(If you use a C mount lens, add a
C mount ring.-option)
2. Connect the video output jack to the monitor video
in jack.
3. Connect power supply. Check the voltage.
2. You can adjust all functions by OSD.
3. This camera has "non-polarity" function.
You can connect 12V DC regardless polarity.
4. Practical small size.
C-MOUNT RING(option)
CS-MOUNT
51
1/4" -20UNC
30.5
MINI BOX CAMERA
SK-B280
MANUAL
36.5
FEATURES
CAUTION AND WARNING
DESCRIPTION OF OPERATION
ACCESSORIES
LENS CONNECTION
DIMENSION
TROUBLESHOOTING GUIDE
C MOUNT RING -(option)
DC-TYPE
① DAMP COIL -
② DAMP COIL +
③ DRIVE COIL +
④ DRIVE COIL -
AUTO IRIS LENS
CONNECTOR
①
②
③
④
OVERVIEW
Mouting hole
±
1/4"-20UNC(20THREAD)
L : 4.5mm 0.2mm(ISO standard)
①Video output :
Power input terminal :
Menu setup jog lever :
Used to connect the video monitor.
Used to connect a 12V DC power supply only.
(Non-polarity)
: Used to access the menu and confirm
selection.
: Used to move the cursor to up or
down.
t : Used to move the cursor to left
or right and change the value.
ㆍENTER
ㆍUp, Down
ㆍLeft, Righ
②
③
①
②
③
If the product is to be put out of operation definitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
Problem
Check point
Too dark or bright
picture
No Power
Poor picture quality
Shrinking picture
Readjust the contrast or brightness
controls on the monitor.
Clean the camera lens.
Readjust lens focus.
Check the condition of the power
sources.
Check for power connection.
