Assembly Instructions
8' x 6'
– Security Shed
1.
Place the floor section on the base you have prepared and
fix the back panel to one side panel screwing through the
vertical battens of the back panel into the battens on the side
panel using 3x 70mm green screws. Repeat when fitting the
other side panel.
2.
Fix the front panel (with door) to the two side panels as in
part 1 using 70mm screws provided. After all the panels are
fitted together, make sure it is all square and the cladding
overlaps the floor.
3.
Place one roof panel on the top the shed. The batten will
fit into the central recess on the front and rear panels.
Repeat for the other panel. Then screw into place using 6x
50mm screws in to each roof panel. Once the roof is screwed
into place, fix the panels to the floor section. Use 3x 70mm
screws for each side panel and 2 screws for each of the front
and back panels.
4.
Fit the long fillet in the gap between the two roof
panels as shown in the photo.
List of parts in fixings pack
---
--------- -
1 x Roll of Felt (10m)
12 x 40mm Galvanised Nails
22 x 70mm Green Screws
26 x 50mm Green Screws
12 x 30mm Wire Nails
100 x 15mm Felt Nails
With all buildings, it is important to provide a firm level base before assembling your shed.
If a concrete base is being used we recommend this does not extend beyond the dimensions of
the shed to stop water falling from the roof and collecting on the concrete base. This can be
avoided by making the base for this shed 2400mm x 1800mm.
Hutton Garden and Landscaping Products
Church Lane, Northwood Green, Westbury-on-Severn, Gloucestershire GL14 1ND www.svw2000.co.uk/hutton
Tel: 01452 762089 Fax: 01452 760993 [email protected]
Summary of Contents for 8' x 6' - Security Shed
Page 3: ......
