DOG TRAINING COLLAR
WITH
GPS TRACKER
MODELS: GPS-DTR 25000-25002-25003
(GPS and training function)
GPS 25000-25002-25003
(no training functioning)
PREPARING THE GPS-TRAINING COLLAR FOR FIRST USE
Charge the collar for7-8 hours. The battery has a standby time of 20 hours when fully charged.
Connect the small USB adapter to theUSB cable, and then the cable to the USB charger. Then con-
nect the charger to the collar 'as shown below picture. Lift the orange plastic protective cover and
connect the charger. Now turn on the collar. To switch it on, hold the back side close to the remote
control USB (where the built-in magnet is) for 1 second at the point where the collar indicator lamp
is located. Then remove the remote control. The red indicator light on the collar will continuously
indicate that the device is charging.
In order to have full charge we need to TURN OFF the collar
with the remote control magnet durring the charging process
After 7-8 hours of charging, remove the charger. To switch off the collar, hold the remote control part
(where the built-in magnet is located) for 4 seconds at the point where the collar indicator lamp is loc-
ated.
The remote control should be charged for 4-5 hours.
Connect the charger to the remote control on the USB connector on the top.
PAIRING AND USE THE GPS-DOG TRAINING COLLAR
The training collar you purchased is already paired with its remote control. If you want to pair it again, follow the
instructions below. The remote control can control up to 9 collars. The remote control has + and - buttons for collar
selection in which to send commands Turn on the remote control from the ON / OFF button, then turn on the collar.
When the collar is lit the red indicator
light of the collar flashes. Press for 4-5 seconds the display light button will now flash the speaker icon on the
screen. The remote control is in tuning mode. Then hold the back of the remote control (where the built-in magnet
near the USB is located) for 10 seconds at the point where the collar indicator lamp is located. Remove the remote
control from the collar after 10 seconds and if you have heard 3 consecutive beeps from the collar, then press the
shock command button for 2 seconds. You will hear a beep, indicating that the sync was successful. Repeat the same
procedure if you want to sync other collars. When you have finished adjusting the collars, press the audio command
button to return the remote control to normal operation. When you press the remote control shockr button, a shock
command is sent to the corresponding collar. Each time you press the audio command or the push button or the
audio + shock button, the screen flashes, indicating that the command is being sent to the collar. The level of
excitement fluctuates with the increasing number of buttons on the remote control from 1 to 8. Level 1 is the lowest
and level 8 is the highest. After use, you can turn off the remote control using the ON / OFF switch.
the remote control to normal operation. When you press the remote control shockr button, a shock command is sent
to the corresponding collar. Each time you press the audio command or the push button or the audio + shock button,
the screen flashes, indicating that the command is being sent to the collar. The level of excitement fluctuates with the
increasing number of buttons on the remote control from 1 to 8. Level 1 is the lowest and level 8 is the highest. After
use, you can turn off the remote control using the ON / OFF switch.
INCLUDING Training Collar, USB Charger, USB Cable, USB Remote Antenna Adapter, Short and long spikes.
want to sync other collars. When you have finished adjusting the collars, press the audio command button to return
the remote control to normal operation. When you press the remote control shockr button, a shock command is sent
to the corresponding collar. Each time you press the audio command or the push button or the audio + shock button,
the screen flashes, indicating that the command is being sent to the collar. The level of excitement fluctuates with the
increasing number of buttons on the remote control from 1 to 8. Level 1 is the lowest and level 8 is the highest. After
use, you can turn off the remote control using the ON / OFF switch.
INCLUDING Training Collar, USB Charger, USB Cable, USB Remote Antenna Adapter, Short and long spikes.
INCLUDING
Training Collar, USB Charger, USB Cable, USB
Remote Antenna Adapter, Short
and long spikes.
