1
Unpack the box
Extra (in case needed)
Zip ties (4)
Zip ties (2)
Armrests
Side panels
Flat washers (8)
Flat washers (2)
5mm Allen screws (8)
5mm Allen wrench (1)
5mm Allen screws (2)
Fasteners (8)
Fasteners (2)
Power cord
Chair base
HT-Navitas Sleep
HT-Novo
DELIVERY AND ASSEMBLY GUIDE
2. Install the side panels.
3. Install the power cord and power on the chair.
4. Press the Power button on the remote control to power it on.
a. Align the four side panel holes with the corresponding mounting holes on the armrest, then push the side panel firmly
into place (Fig.A).
b. Using a flat-head screwdriver, pry the top of one of the fasteners up off of the fastener base and hold it in that position (Fig.B).
c. Using your other hand, locate one of the four side panel mounting holes on the inside of the armrest (Fig.C).
d. Push the base of the fastener firmly and completely into the hole, then push the top of the fastener firmly inward to lock it.
e. Repeat steps (b) and (c) to install the other three fasteners.
NOTE:
Access the upper rear mounting hole from the inside of
the arm, near the seat cushion. To install the upper front fastener, you may want to rotate the foot and calf massager for easier access.
f. Repeat steps (a) to (e) to install the other side panel.
a. Plug the power cord into the power jack on the back of the chair.
b. Plug the other end of the power cord into a grounded 120V outlet.
c. Turn the power switch on the back of the unit to On (I).
When you have ensured that the area around the chair is free from children and pets
(and will remain that way for the duration of the chair’s use), select CONTINUE.
Power cord
Power switch
Side panel
Fig. A
Fig. B
Fig. C
Fasterner
Mounting holes
