manualshive.com logo in svg
background image

RGBW RF Remote Control

1. Product Introduction:

Before you begin, read all warnings and installation instructions and save for future use.

1/3

Model: H-2819S

2. Product Dimension:

Four zones/areas
Press-button RGB+W controller

Receivers work with WIFI-RF converter to be controlled by smart phone

SR-2819S RGBW remote controller has 4 different zones. It can get Red/Green/Blue/White color 

directly.  The  remote  controller  can  save  up  to  3  colors  or  modes  into  corresponding  buttons 

(S1,  S2,  S3)  for  each  zone.  You  can  choose  any  color  through  color  wheel.  You  can  set  the 

system as RGB 3-channel output or RGBW 4 channel output.

120mm (4.72”)

55mm (2.16”)

17mm (0.66”)

Ÿ

This product is intended to be installed and serviced by a qualied licensed electrician. Install in accordance with 
the National Electric Code, and local regulations. Disconnect power before installing or servicing. Only power with 
a regulated (listed) constant voltage Class 2 power supply (12-24V DC).

Ÿ

Ensure applicable wire is installed between driver, xture, and any controls in between. When choosing wire, factor 
in voltage drop, amperage rating and type (in-wall rated, wet location rated, etc.). Inadequate wire installation 
could overheat wires and cause re.

Ÿ

This product is rated for indoor installation and can be used for dry locations. Avoid the direct sun light. 

Ÿ

Do not modify this product beyond the instructions in this guide or the warranty will be voided.

Ÿ

Wiring  diagrams  in  this  installation  guide  for  basic  installations.  Please  carefully  review  your  installation  before 
proceeding.

Ÿ

Always be sure to mount this unit in an area with proper ventilation to avoid overheating.

Ÿ

Please check if the output voltage of any LED power supplies used comply with the working voltage of the product.

Ÿ

Never connect any cables while power is on and always assure correct connections to avoid short circuits before 
switching on.

Ÿ

Please ensure that the cable is secured tightly in the connector

Ÿ

For updated information please consult your supplier.

Safety & Warnings

HUEDA

 LED | CALGARY, AB | CANADA 

Copyright © 2016 HUEDA™ LED, A division of LED World Inc.. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).

Отзывы: