Tools Required:
q
Flat Blade Screwdriver
q
Thread Sealant
q
3/32" Allen Wrench
9/30/14 EC 140930036 Status A
Part No. 93054366
Your KIM fixture is supplied with 1/2"
NPSM male mounting threads and locknut.*
*Consult Kim Landscape Lighting Collection Catalog for mounting device options.
C24 LED Accent Light
Installation Instructions
16555 East Gale Avenue
City of Industry, CA 91745-1788
626/968-5666 • FAX 626/968-5716
2.
Attach fixture leads to circuit leads
observing polarity, i.e.; green-
to-ground, white-to-common
and black-to-voltage with wire
connectors by others.
3.
T
ighten locknut to ensure selected
orientation. Tighten screw under
J-Box cover, (if supplied), to
secure fixture. Attach cover.
1.
Apply thread sealant onto exposed
fixture threads to keep moisture
from entering junction box. Thread
fixture onto junction box cover or
mounting device.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: Fixtures must be grounded in accordance with local codes or the
National Electrical Code. Portable spear or tree mounts using a cord and plug must be plugged into a
receptacle protected by a Ground Fault Circuit Interrupter (GFCI) in accordance with the National Electrical
Code. Failure to take these steps may result in serious personal injury. Lighted lamp is HOT!
AVERTISSEMENT: Les luminaires doivent être mis à la terre conformément aux codes locaux ou
au National Electrical Code. Lance ou arbres supports portables utilisant un cordon et la prise doivent
être branchés dans une prise protégée par un disjoncteur différentiel (GFCI) conformément au Code national
de l’électricité. Le défaut de prendre ces mesures peut entraîner des blessures graves. La lampe allumée
est CHAUD!
NOTE: All wiring must be done by a qualified electrician.
REMARQUE: Tout le câblage doit être fait par un électricien certifié.
See additional warnings and cautions on p. 3.
KEEP THIS SHEET FOR FUTURE REFERENCE.
!
!
!
!
Locknut
Thread
Sealant
J-Box
Top
Gasket
C24
Make certain the electrical supply is
OFF
before starting fixture installation.
Assurez-vous que l’alimentation électrique est coupée avant l’installation du luminaire.
!
!
