Narrowest Diameter
of Ferrule
Pin
Spring Plate
Owner’s Manual
GlideVault
™
Item No. 75404
Customer Service: PO Box 1848, Grand Island, NE 68802-1848
1-877-214-4470 | Email: [email protected]
21SNAP0036 | 10/2021
Ext. Dimensions: 15.9" x 12.2" x 4.4"
Int. Dimensions: 13.5" x 9.5" x 3.14"
LOW BATTERY WARNING
If the batteries become weak, the keypad will remain red during operation.
Replace batteries immediately to ensure proper operation of the safe.
SECURITY CABLE INSTALLATION
To maintain the security of the safe, either use the included security cable or
bolt the safe to a secure structure.
USING THE SECURITY CABLE
Wrap the security cable around a secure object and place the ferrule end
through the loop in the cable. With the drawer open, snap the narrowest
diameter of the ferrule into the back of the safe by gently pushing the ferrule
end against the spring plate and sliding the ferrule down. As the drawer
closes, it presses against the spring plate and locks the ferrule in place.
To remove the security cable, open the safe and press the pin above the
ferrule while lifting the ferrule.
BOLTING DOWN THE SAFE
Remove the drawer by gently pulling it out while pressing the plastic tab on
the left side up, and the tab on the right side down.
Mark and pre-drill holes before installing the appropriate fasteners for your
application.
To reinstall the drawer, carefully align the slides on each side and push the
drawer in. The tabs should click into place.
Weight: 26 Lbs
Power: 4 AAA batteries (not included)
Plastic Tab on
Side of Drawer
