m
WARNING
PERSONAL INJURY
DO NOT USE these products as safety or emergency stop
devices or in any other application where failure of the product
could result in personal injury.
Failure to comply with these instructions could result in
death or serious injury.
Installation and Technical Manual for the
Limitless™ Series WLS Limit Switch
Used in conjunction with the Limitless™ WPMM or WDRR Series
Sensing and Control
Issue 3
50054911
m
WARNING
Honeywell does not recommend using devices for critical
control applications where there is, or may be, a single point of
failure or where single points of failure may result in an unsafe
condition. It is up to the end-user to weigh the risks and benefits
to determine if the products are appropriate for the application
based on security, safety and performance. Additionally, it is
up to the end-user to ensure that the control strategy results in
a safe operating condition if any crucial segment of the control
solution fails. Honeywell customers assume full responsibility
for learning and meeting the required Declaration of Conformity,
Regulations, Guidelines, etc. for each country in their distribution
market.
m
WARNING
RF EXPOSURE
To satisfy FCC RF exposure requirements for mobile transmitting
devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons
during device operation To ensure compliance, operation at
closer than this distance is not recommended. The antenna
used for this transmission must not be co-located in conjunction
with any other antenna or transmitter.
Failure to comply with these instructions could result in
death or serious injury.
m
WARNING
The WLS must be installed in accordance with the requirements
specified in this document in order to comply with the specific
Country Communication Agency requirements (i.e., FCC, IC,
ETSI, ACMA, etc.). See Section 3 as this requires choosing the
correct Country Use Code and thus allowable antenna and/or
cable usage.
CAUTION
Power to the WLS should not be applied (ensure battery is
removed) during installation of antenna as damage could occur
to the WLS electronics.
