Document 800-04882 – Rev E – 11/09
4 Inch Dome Camera
Quick Install Guide
Document 800-04882 – Rev E – 11/09
FCC Compliance Statement
Information to the User
: This equipment has been tested and found to comply with the limits for a
Class B digital device. Pursuant to Part 15 of the FCC Rules, these limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected
•
Consult the dealer or a radio/TV technician for help.
Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Manufacturer’s Declaration of Conformance
The manufacturer declares that the equipment supplied with this guide is compliant with the
essential protection requirements of the EMC directive 2004/108/EC and the Low Voltage Directive
(LVD) 2006/95/EC, conforming to the requirements of standards EN 55022 for emissions,
EN 50130-4 for immunity, and EN60065 for Electrical Equipment safety.
Preparation
Camera Mounting
Camera Adjustment
1
2
3
Contents
Fully assembled camera
Hardware kit
Mounting templates
This guide
Operating Notes
Warnings (where applicable to your locale)
Installation and servicing should be performed only by qualified and experienced technicians
to conform to all local codes and to maintain your warranty.
WARNING!
The use of CSA Certified/UL Listed Class 2 power adapters is required to
ensure compliance with electrical safety standards.
WEEE (Waste Electrical and Electronic Equipment).
Correct disposal of this product
(applicable in the European Union and other European countries with separate collection
systems). This product should be disposed of, at the end of its useful life, as per applicable local
laws, regulations, and procedures.
Power Supply
This dome camera can operate on 24 VAC or 12 VDC.
Operating Conditions
Avoid:
•
Viewing bright objects (for example, light fixtures) for extended
periods
•
Operating or storing the unit in the following locations.
•
Extremely humid, dusty, hot/cold environments (where the
operating temperature is outside the recommended range of
14°F to 122°F [-10°C to +50°C])
•
Close to sources of powerful electromagnetic radiation, such
as radio or TV transmitters
•
Close to fluorescent lamps or objects reflecting light
•
Under unstable light sources (may cause flickering)
Product Dimensions
Contact Information
4.0
6
”
(106.1 mm)
2.63
”
(66.9 mm)
+1.800.796.CCTV (North America only)
Document 800-04882 – Rev E – 11/09
© 2009 Honeywell International Inc.
All rights reserved. No part of this publication may be reproduced by any
means without written permission from Honeywell Systems Group. The information in this publication is
believed to be accurate in all respects. However, Honeywell Systems Group cannot assume responsibility for
any consequences resulting from the use thereof. The information contained herein is subject to change
without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
∅
5.74
”
(
∅
145.9 mm)
3.97
”
(100.8 mm)
4.7
6”
(12
1.0
M
M)
∅
0.22”
(
∅
5.5 mm)
2.04
”
(5
1.
75 mm)
Flush mount
Surface mount
5.74
”
(145.9 mm)
