background image

ZRP210 Instructions

P/D 102406

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC

.

0699-01

1

 Radio Frequency Controlled, 10A, 230 VAC,

Plug-In Appliance Module (Euro-UK)

ZRP210

HomePro

RF Home Automation

 ZRP210 PLUG-IN APPLIANCE MODULE

The ZRP210 Plug-In Appliance Module is a component of the HomePro lighting control system.   Plug the Appliance
Module into a wall outlet and plug a load into the Appliance Module.   Remote control of the ON/OFF of  the connected
load is possible the ZTH200 RF Wireless Controller (sold separately).

This plug-in Appliance Module is designed to work with other HomePro lamp and appliance controls and Z-Wave
enabled devices of other types.

As part of a HomePro network, the ZRP210 can act as a wireless repeater to insure that commands intended for
another device in the network are received.  This is useful when the device would otherwise be out of the radio range
of the wireless controller.

There are no field repairable assemblies on this unit.  If service is needed, the unit must be returned where purchased.

INSTALLATION

Plug this Appliance Module into the wall outlet near the load to be controlled, and plug the load into the Appliance
Module.  Follow instructions in the Wireless Controller operating instructions for details to add this module under the
command of the Wireless Controller.  

The ZRP210 must be in its permanently installed location.

  Make sure the

load to be controlled is 10 amps (2300 watts) or less.

Appliance Module Button

The Appliance Module has a button on the face (see picture above) that can switch the attached load ON and OFF,
and is also used to configure the Appliance Module to operate from the Wireless Controller.  Using the Wireless
Controller, the Appliance Module can be switched ON and OFF remotely, and can be included in groups of modules
(a group can also be a single module) that operate at the same time, or a scene that sets a lighting mood if the load
is a lamp.

Switching power on and off (locally)

When the button on the Appliance Module is pressed and released, the power will toggle. This means that power
will be turned OFF if it was ON and turned ON if it was OFF.

Child Protection

The Appliance Module can be set in a child protect mode by the Wireless Controller. When this mode is active,
a user will have to press the button on the Appliance Module 3 times rapidly to activate the attached load. The
module operates normally when controlled by the Wireless Controller.

Other Functions

The button on the Appliance Module also plays a role as a reset in addition to adding module to groups and scenes.
This is described in more detail in the Wireless Controller instructions.

    Button functions

1.  Adds module under the command of  Wireless Controller.
2.  Provides local ON and  OFF (push and release).

Note:

  This module must be “Included in the

Network” 

only where it will be permanently

installed

.  The proper operation of  this node in the

mesh network is dependent on it knowing its
location with respect to other nodes.  You cannot
“test bench” configure this module.

Reviews: