9-2
REMOTE CONTROLLERS OPERATION
9.1
WIRELESS REMOTE CONTROL FUNCTION
PRECAUTIONS:
x
This controls the operation of indoor unit. The range of control is 7 meters. If indoor lighting is controlled electronically, the
range of control may be shorter, in some cases; the control signal may not be received. This unit can be fixed on a wall
using the fixture provided. Before fixing it, make sure the indoor unit can be controlled from the remote controller.
x
Press buttons only with fingers. Do not press buttons by any other item, as it may damage the buttons.
x
Do not put the remote controller in the following places.
o
In direct sunlight.
o
In the vicinity of a heater.
x
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission capability.
x
After new batteries are inserted into the remote controller, the unit will initially require approximately 10 seconds responding
to commands and operating.
x
Once the outdoor unit stops, it will not restart for about 3 minutes (unless we switch OFF and ON the power or unplug and
plug back the power cord again.) This is to protect the device and does not indicate a failure.
x
If you press the FUNCTION selector button during operation, the device may stop for about 3 minutes for protection.
9.1.1.
NAMES AND FUNCTIONS OF WIRELESS REMOTE CONTROL UNIT
9.1.1.1
RAR-3R5 (For RAS-SX8)
Transmission indicator
The transaction indicator lift when a signal is sent
ROOM TEMPERATURE Button
Press this button to set the room temperature
START/STOP BUTTON
Press this button to start operation. Press
again to stop operation
HEAT Button
Press this button to start heating
operation
Transmission Part
DEHUMIDIFY Button
Press this button to start dehumidify
operation
COOL Button
Press this button to start cooling
operation
DRY COOL Button
Press this button to start dry cooling
operation
IONIZED MIST Operation Button
Press this button to start ionized mist
operation
HUMIDIFY Button
Press this button to set the humidify for
dehumidify and dry cool operation
SLEEP TIMER Operation Button
Press this button to start sleep timer
operation
(When the door is open)
OPERATION Selector
Press this button to select operation mode
VERTICAL AIRFLOW Button
Use this button to swing the vertical air
deflector or to adjust the angle to your
preference
HORIZONTAL AIRFLOW Button
Use this button to swing the horizontal air
deflector or to adjust the angle to your
preference
PREFERENCE Button
Press this button to select your preferred mode
TIMER Button
SET TIME Button
Use this button to set and check the current time
RESET Button
Press this button after the batteries are replaced
and when the air-conditioner does not function
properly
ON/OFF Button
Use this button to set or cancel the function
selected by the function selector
FUNCTION Selector Button
Each time when you press, blinking changes in
the sequence
FAN SPEED Button
Press this button to select fan speed
MANUAL CLEAN Button
Start filter cleaning operation while the
air-conditioner operation is stopped
AIR PURIFYING Button
Press this button to start stainless
plasma air purifying (FAN) operation
