Installation Instruction for 22400 ARIES Magnifying Mirror
INSTALLATION INSTRUCTIONS
1. Determine appropriate location and height.
2. Use wall bracket as a guide and mark location of screw holes for
the brackets on the wall.
CAUTION:
Check the intended wall location for its structural strength.
Injury to persons and damage to the mirror and /or mounting surface
may result if the mirror is pulled from the surface. To limit the likelihood
of such injury or damage, mount the mirror on structural wall material
that is sound.
3. Drill the holes in wall at marked location. Insert wall anchors in each
hole. Install wall bracket onto wall using the mounting screws provided.
Secure tightly.
MOUNTING INSTRUCTIONS
Only connect to alternating current 230-240 V
Electrical work to be carried out by a qualified electrician following IEE Wiring
Regulation 16th Edition. In rooms with showers and baths, the mirror has to be
installed in consideration of the safety distances according at Building Regulations Part P.
Safety distances:
Electrical appliances must be wired at a minimum distance of 60 cm
fro m shower cabins and bath tubs and 120 cm from shower heads.
.
HOW TO USE
Use the adjustable extension arm to retract or extend the mirror.
CARE AND CLEANING
Do not submerge mirror in the water or use excessive amount of water for cleaning
purposes.
Do NOT use sponges or cloths that may damage the surface.
Do NOT use detergents that contain bleaching agents.
Chrome Surfaces
Polish with a soft, clean cotton cloth.
Mirror Lens
Polish with a dry, soft cotton cloth.
DISPOSAL
this product must be delivered at the end of its service life at a collection
point for the recycling of electric and electronic devices.
Castle House, 21-23 Station Road, New Barnet, Herts. EN5 1PH
Tel: 020 8441 0352 / Fax: 020 8441 0219
Email: [email protected] / Web: www.hib.co.uk
For further information on the range of Bathroom Products available from
HiB including Mirrors, Heated Mirrors Pads, Bathroom Cabinets, Furniture &
Bathroom Lighting please contact your local Bathroom Retailer.
WARNING: Be sure the mirror is not in position where it can reflect sunlight.
Reflected sun can cause fire.
Oct. 2009
.
Mounting:
1. Remove the mounting plate by removing the screws from the wall bracket.
2. Fasten the mounting plate to the wall.
3. Standing in front of the mirror-the mirror just be mounted with the pull cord
at the bottom.
4. Place the mounting bracket over the mounting plate and press in place. Proceed
to secure the mounting bracket to the wall plate.
5. The joints of the arm can be adjusted with a screwdriver.
