OPERATION
Model CB-2010
Motion Sensor
Light Control with
Protective Lamp
Shields
© 2000 Heath Co. a div. of DESA International
598-1090-00
* resets to Auto Mode at dawn.
TEST
Light Control
Sensor
Cover
Plate
Lamp
Holders
6 Screws
(3 sizes included)
Gasket
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
This package includes:
Requirements
•
The Light Control requires 120-volts AC.
•
If you want to use the Manual Mode, the control
must be wired through a switch.
•
Some codes require installation by a qualified
electrician.
•
This product is intended for use with the enclosed
gasket and with a junction box marked for use in
wet locations.
TEST 1 5 20
ON-TIME
Put ON-TIME switch on the sensor
bottom to TEST.
MANUAL MODE
ON-TIME
TEST 1 5 20
... back on.
AUTO
1 Second OFF
then...
Put the ON-TIME switch in the 1, 5 or
20 minute position.
Move ON-TIME Switch
to 1, 5 or 20 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
Note: When first turned on wait about 1
2
minutes
for the circuitry to calibrate.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the
AUTO mode.
Mounting Bolt
Mounting Strap
Test
5 Sec
x
x
Auto
1, 5, 20 min.
x
Manual Until Dawn*
x
Mode: On-Time:
Works: Day
Night
Rubber Plug
Plastic Hanger
2 PAR Lamps
2 Wire
Connectors
