INSTALLATION SHEET
Midrange Control Blocks, Track and Trim Caps
Control Blocks:
1631, 1632, 1633;
Track:
R27, 1602, R27HB;
Trim Caps:
1621, 1622
Read Instructions Before You Cut or Mount Track
To cut track to length, make sure stop holes for control blocks do not
interfere with hole for mounting track. If necessary, cut both ends of track.
Cut Track
Mount Track
Through-bolt track per instructions provided with track.
Deadending Line at End Control
Remove any burrs on edges of track. Press 1621 or 1622 trim caps in place.
Install Control Blocks
1602, 1616, 1617
Use 20 mm screws.
1618
Use 35 mm screws.
Position control block flush with end of track. Drive screw firmly
against top surface to mark track, then loosen. Slide control block away.
IMPORTANT: Drill
21
/
64
" (8.5 mm) hole only through top suface of track.
Do not use screw hole in control block as drill guide.
19 mm
(
3
/
4
")
83 mm (3
1
/
4
")
Drill size
8.5 mm (
21
/
64
")
To determine correct track length, make sure track ends, without trim caps,
are 19 mm (
3
/
4
") from edge of cockpit coaming.
Secure control block to track by tightening correct screw into hole.
Install Trim Caps
.
No
Yes
Cockpit Installation
IMPORTANT: Insert loop down from above.
It might be necessary to put trim caps, control blocks, and traveler car on
track before mounting. Slide control assemblies onto track with bumper
facing car. Keep control assembly loose so it can be moved out of the way
while installing track.
USA
–
Tel:
(+1) 262-691-3320 •
Web:
www.harken.com •
Email:
Italy
–
Tel:
(+39) 031.3523511 •
Web:
www.harken.it •
Email:
WARNING! Strictly follow all instructions to avoid an accident,
damage to your vessel, personal injury, or death. See
www.harken.com/manuals for additional safety information.
