Your Hearing System.
Operating Element.
Replacing the Battery.
Turning Your Hearing Systems on and off.
Optional Functionalities.
1
Wire
– connects the speaker unit to your hearing systems
1a
Earhook
2
Microphone / Microphone shield
3
Push button
– switches between listening programs and/or
changes the volume level (depending on individual fitting)
4
Battery door
5
Dome (Olive)
6
Retention piece
– helps prevent the dome and wire from moving
out of the ear canal
7
External receiver
7a
Slim tube
(
mini tube
)
8
Earmold
Which System Goes in Which Ear:
Red = right ear Blue = left ear
Option: Slim tube
(
with mini tube)
•
Refer to the remote control user guide.
Option: Remote control
0124
Conformity to directive
93/42/EEC concerning
medical devices
Low Battery Warning
Two long beeps indicate the hearing system battery is
low. After the low battery warning, sounds may not be
as clear. This is normal and can be fixed by changing
the batteries in the hearing systems.
If you are not able to hear the low battery warning,
your hearing system professional can change its pitch
or loudness. If you prefer, it can be turned off entirely.
13
312
Battery type:
•
Open the battery door.
•
Close the battery door.
•
Insert the battery into the battery
compartment, so that the
negative pole
faces into the door.
–
+
With a new battery, it may take a few
minutes for the battery to develop its full
output. Only then should you close the
battery door.
!
With Battery Door
1. On:
•
Close the battery door fully.
Note: It may take 5 seconds before the
hearing system turns on. Your hearing healthcare
provider can increase the start up delay if
required.
3. Open:
•
Fully open the battery door to access and
change the battery.
Note: To switch the hearing system on
your ear on or off, hold the device between your
thumb and forefinger.
Open and close the battery compartment with
the forefinger of your other hand. Use the index
finger of your opposite hand to open and close
the battery door.
2. Off:
•
Partially open the battery door.
With Push-
button
With Remote Control
Program change
Volume control:
right device – louder, left device – quieter
Combination:
Program change – right device and
volume control – left device
Combination:
Volume control – right device and
program change – left device
Volume control:
right/left device – louder
Volume control:
right/left device – quieter
Without Operating Element
•
Refer to the remote control user guide.
•
Refer to the remote control user guide.
With Remote Control
If the pushbutton has been configured as a volume control, you can
adjust the volume level by pushing the + or – button.
Push the button on your right hearing system to increase the volume
in both hearing systems.
Push the button on your left hearing system to decrease the volume
in both hearing systems.
As you change the volume, your hearing systems will beep.
With Pushbutton
With Lever
•
If the lever has been configured as a volume control, you can adjust
the volume of your hearing systems.
Press up to increase; press down to decrease. As you change the
volume level, your hearing systems will beep.
Volume setting
Suggested volume level
Turning volume up
Turning volume down
Maximum volume level
Minimum volume level
Beeps
1 beep
short beep
short beep
2 beeps
2 beeps
Hearing Program/Description
1
2
3
4
•
Use the program pushbutton to select one of the hearing programs
individually programmed for you.
•
When changing, your hearing system uses signal sounds to indicate
which program you have selected.
•
You can thus adjust your system to the relevant hearing situation.
With Pushbutton
•
Refer to the remote control user guide.
With Remote Control
Program 1 (e.g. AutoSurround)
Program 2 (e.g. speech in noise)
Program 3 (e.g. PhoneConnect)
Program 4 (e.g. music)
PhoneConnect
Wireless synchronization
(if enabled)
1 beep
2 beeps
3 beeps
4 beeps
short melody
Opposite ear beeps the same
as side being adjusted
•
If wireless synchronization is enabled, then changing the volume or
program setting on one hearing system, will automatically make the
change to both hearing systems at the same time. Wireless synchroni-
zation works for both the push button and the lever.
•
Please refer all questions concerning your hearing system to your
hearing system professional.
The Bi feature enables you to hold a phone to one ear and hear the
sound clearly in both ears. No accessories are required.
Wireless Synchronisation (BiLink)
Binaural Phone (BiPhone)
Telephone Coil
The telephone coil allows inductive signal reception (e.g.,
when telephoning). The reception of noise through the micro-
phone is reduced or suppressed.
Tinnitus Manager
If your hearing system professional has configured both a Tinnitus
Manager program and a volume control, you can adjust the Tinnitus
Manager level while you are in the Tinnitus Manager program.
•
allows you to turn the hearing systems on with an automatic delay of
5, 10, or 15 seconds to avoid feedback (whistling).
Power-on-Delay
Switching Hearing Programs.
Adjusting Volume.
With Lever
The lever on your hearing systems can be
set up as a volume control.
quieter
louder
5
1
6
7
8
7
1
sound/soundHD
2
2
3
4
2
2
2
2
3
3
4
4
jam/jamHD
1a
8
7a
sound 13
jam 13 P
jamHD RS13 P
soundHD 13
sound 312
jamHD S13 P
soundHD 312
soundHD S312
jamHD S312 M
5
soundHD S312e
Hörsystem:
FCC ID:
sound 13
VMY-UWBTE1
soundHD 13
VMY-UWNB1
sound 312
VMY-UWCRT2
soundHD 312
VMY-UWNB0
soundHD S312
VMY-UWNB2
soundHD S312e
VMY-UWNB2
jam 13 P
VMY-UWBTE1
jamHD S13 P
VMY-UWNB1
jamHD RS13 P
VMY-UWNB3
jamHD S312 M
VMY-UWNB4
