Secure the carrier to the other roof bar by unlocking the
quick release handle. Rotate the quick release handle
anti-clockwise so that the swing arm can be freely
rotated out of the way.
4
1
The following operation must be completed before the carrier
is mounted to the vehicle roof bars.
The carrier must be
adjusted to suit the particular cycle to be carried.
Position the carrier on the floor and place the cycle onto
the carrier. Raise the clamping arm up to the cycle frame.
A
B
C
Slide the bracket to the point at which the carrier crosses the
roof bar and rotate the arm around underside of the roof bar.
Fit the head of the coach bolt into the notch of the swing
arm. Push the coach bolt as far as possible into the notch
and close the handle to clamp the carrier to the roof bar.
The tension may be set by turning the handle clockwise,
checking that the quick release handle will close on each
full rotation.
5
B
C
A
8
Lift your cycle onto the carrier ensuring both tyres are
positioned centrally on the tyre locators.
6
To make fitting of the cycle easier, secure the front wheel
using the 52cm strap. Warning: Ensure the strap is inserted
through the cambuckle in the correct direction.
7
Release the jaws of the clamping assembly by unlocking,
lifting the handle and rotating it anti-clockwise.
The clamp may be unscrewed and reversed to provide
either left or right access.
2
To adjust the position of the base plate, loosen the four M6
nuts that are situated either side of the longitudinal bar.
Offer the clamping arm to the frame of your cycle by sliding
the base unit along the longitudinal bar.
Once in the correct position, tighten the nuts to 7Nm
and fit the carrier to the vehicle.
Secure the Front of the carrier by releasing the quick release
handles. Rotate the handles anti-clockwise so the L-Shaped
Clamps can be freely attached around the roofbar. Take care
to ensure the clamps are located in the slots. Close the quick
release handles to clamp the carrier to the roofbar.
The tension can be set by turning the handles clockwise,
checking that the quick release handles will close on
each full rotation.
7Nm
3
