hager TR351, User Manual

Page: 1 / 7

1 6T 7299-00b
6T 7299-00b
TR351
§
Unidirectional radio input
concentrator
User instructions
•
TX100 in "Prog", "Num" or "Visu" mode: the channel number
displayed on the concentrator is not yet numbered on the
TX100
Combination
OFF
OFF
ON
ON
OFF
OFF
ON
ON
Flashes
OFF
The TR351 concentrators increase the number
of unidirectional radio products in a combined
system (radio/wire-based) by grouping
together the inputs that perform the same
function. The TR351 concentrators are
equivalent to 24- or 32-channel input modules,
depending on the type of
system (TX100 or ETS). They are part of the
Tebis installation system.
Configuration
●
TX100 V1.7.0 or later: a description
can be obtained from the manufacturer.
●
ETS : application software TL351 :
the database and description can be
obtained from the manufacturer.
Functions
●
24 channels available in the TX100
configuration.
●
32 channels available in the ETS
configuration.
●
Maximum concentration of 24 radio inputs
per channel.
●
View of status by 2x8 segment display.
●
Possibility to restore the factory settings
for the product.
●
Possibility of deleting links created from the
product.
The precise functions of these products
depend on the configuration and settings.
Wiring and start-up
Remove flap
’
using a screwdriver and
connect the product to the bus.
Technical characteristics
Supply voltage
30V DC
Dimensions 203 x 77 x 26,5 mm
Degree of protection IP 30
Operating temperature 0 °C —> + 45 °C
Storage temperature - 20 °C —> + 70 °C
Receiver class EN 50428
Transmission frequency 868.3 MHz
Display
The table below shows the product status according to LEDs

and
Œ
and the display
‘
.
*
: Display only visible when programmed by the TX100.
**
: Display only visible when programmed by the ETS3.
10
9
*
7
*
6
5
3
1
2
*
8
4
LED

LED
Œ
Display
‘
Description
14
13
11
12
**
15
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
OFF
OFF
Flashes
ON
OFF
OFF
OFF
OFF
OFF
Factory return of the TR351 is in progress
Deleting all the radio inputs stored in the TR351.
This takes at least 5 seconds
TX100 in "Prog", "Num" or "Visu" mode: the input selected on
the TX100 is not connected to the concentrator
TX100 in "Prog", "Num" or "Visu" mode:
the input selected on the TX100 is linked to the concentrator
TR351 in "Delete links" mode:
delete all the links with the selected channel
TR351 in "Create links" mode:
the next activated radio input will be linked to the number
displayed
TR351 in "Create links" mode:
store the current link
TR351 in "Delete links" mode:
the link between the next radio input and the displayed
number will be deleted
TR351 in "Delete links" mode:
delete the current link
Normal mode
A unidirectional radio input linked to the TR351 with a low bat-
tery level has sent a telegram
TR351 in "Visu" mode: "Visu" mode is active
TR351 in physical address mode
TR351 in ETS radio learning mode
Functions available in the Normal
and Display modes:
Physical addresses:
1
.
Enter the “Physical address” mode:
combination
C
2
.
Exit the “Physical address” mode:
combination
C
Associate a radio input with a channel:
1
.
Enter the "Create links" mode:
combination
D
2
.
Select the channel:
combination(s)
A and/or combination(s) B
until the required channel is displayed
3
.
Briefly activate the radio input to be linked
4
.
Exit the “Create links” mode:
combination
D
Delete radio links associated with a
channel:
1
.
Enter the “Delete links” mode:
combination
E
2
.
Select the channel: combination(s) A and/
or combination(s) B until the required
channel appears
3
.
Briefly activate the radio input to be deleted
4
.
Exit the “Delete links” mode:
combination
E
Delete all the radio links associated with a
channel:
1
.
Enter the “Delete links” mode:
combination
E
2
.
Select the channel: combination(s) A and/
or combination(s) B until the required
channel appears
3
.
Delete all the radio links:
combination
F
4
.
Exit the “Delete links" mode:
combination
E
Delete all the radio links stored in the
TR351:
Delete all the radio links: combination F
Reset the TR351:
Reset the TR351: combination G
Display the channel(s) associated with a
radio input:
1
.
Enter in “Visu" mode: combination A or B
2
.
Briefly activate the radio input several times
in order to view all of the channels with
which it is linked.
Keys

and
Ž
The table below shows the changes in product
status according to the type and the combinations
of
the and buttons:
A
Press
C
Press
D
Press and hold
E
/
F
Press and hold
G
Long press and
hold
B
/
/
Press
/
Press and hold
Press and hold
Long press and
hold
Press
Press and hold
10 sec 2 sec
Press
Long press and hold
Length of pressure on the keys
Caution:
- This device must be installed only
by a qualified electrician.
- Not to be installed outside.
Reference
TU204A
≥ 12.6
TU224A
≥ 10.6
TR302A
≥ 10.6
TR304A
≥ 12.6
TR302B
≥ 10.6
TR304B
≥ 12.6
TU208A
≥ 14.6
Compatibility
It is necessary to respect the following
restrictions for an optimal use of TR351
Datecode
TD100
≥ 11.6
TD110
≥ 11.6
TD111
≥ 12.6
TD200
≥ 12.6
TD101
≥ 13.6
TD201
≥ 19.6
TD211
≥ 14.6
TD300
≥ 10.6
TD301
≥ 13.6
TD210
≥ 14.6
TD310
≥ 13.6
TD250
≥ 19.6
TD251
≥ 10.6
TK301
≥ 35.6
TD311
≥ 14.6
TK302
≥ 35.6
4
3
7
5
1
6
2
BUS
Hereby, hager Controls, declares that this unidirectional
radio input concentrator is in compliance with the essential
requirements and other relevant provisions of Directive
1999/5/EC.
The CE declaration can be consulted on the site :
www.hagergroup.net
Usable in all Europe
RF
tebis
TP
Bus
30 V
230V~
°
§