6481R-2 / 6481ER-2: DELUXE TOILET SEAT RISER;
ASSEMBLY & OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
6481R-6481ER-INS-LAB-RevA19
1
Tools required: Phillips or blade screwdriver
WARNING: Important! Read and understand these instructions before installing or using
the Toilet Seat Riser. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If the
toilet seat riser is not properly assembled and installed, personal injury and damage to the
toilet seat riser could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could
cause personal injury and damage to the toilet seat riser.
WARNING: This product has a weight limit of 300 lb, EVENLY DISTRIBUTED.
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov
.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly, installation or use of this product.
INTENDED USE
The toilet seat riser is intended for use by those who have difficulty sitting down on or standing up
from the toilet.
INSTALLATION
1. Remove toilet seat riser and
hardware, shown above, from
carton and protective packaging.
2. At the toilet, lift the cover plates
at top rear toilet bowl rim,
exposing the bolts holding the
seat and lid to the toilet bowl.
3. Use a Phillips or blade
screwdriver, whichever is appropriate, to unscrew toilet seat bolts by turning counterclockwise.
4. Remove the toilet seat and lid from the toilet bowl and set them aside.
5. Place the toilet seat riser over the toilet bowl rim so that the toilet seat riser mounting holes align
with the toilet rim holes.
6. Place the toilet seat and lid on top of the toilet seat riser so that the seat/lid holes align with the
riser and rim holes.
7. Install a washer on one of the long bolts included in the box and insert
it through the top of the toilet seat lid, toilet seat riser, and toilet bowl
rim.
8. Place a washer and wing nut on the end of the long bolt that protrudes
through the bottom of the toilet bowl.
9. Use a Phillips or blade screwdriver, whichever is appropriate, to turn
the bolt clockwise until toilet seat riser and toilet seat lid are snug. Do
not overtighten.
10. The toilet seat riser should now be securely installed on the toilet
bowl, as shown at right. To ensure that you have a proper fit,
intentionally shake the toilet seat riser to ensure proper placement and
fit. The toilet seat riser should not move; if it does, re-install.
6481R-2 6481ER-2
