Manual for WM110
Digital Wireless Audio System 2.4GHz
Page 1/2
General Settings:
1. First turn on the receiver and adjust the channel.
2. Secondly turn on the transmitter. The display will show the same channel as the
receiver and an “A” symbol is shown. The display from the transmitter will also show the
“A” symbol and the connection between receiver and transmitter has been made and is
OK. If you turn on a 2
nd
transmitter the display will show a “B” symbol and the same
channel as the receiver. The recei
ver will also show the “B” symbol and the connection
between the receiver and the 2
nd
transmitter has been made and is OK.
All 3 devices will show the same channel.
3. One receiver connects to a maximum of 2 transmitters and will function
without any interference.
4.
If you first turn on the transmitter it will display the symbol “- -“ which means
“waiting for connection”. You can then turn on the transmitter and adjust the channel.
The display on the transmitter will show the same channel as the receiver and the
symbol “A”. The connection between receiver and transmitter has been
made and is OK.
5. The channel on the transmitter will be changed by the receiver.
6. For example: If you change the channel on the receiver from 09 to 12 it takes about 10
seconds until the new channel 12 is shown on the display of the transmitter. If you do
not want to wait for 10 seconds, you can turn the transmitter off and on. The Channel
will be automatically changed to 12 on the transmitter.
Functions:
1. The transmission distance is more than 30 meters.
2. The battery life is over 5 hours.
3. One receiver can do the connection to a maximum of 2 transmitters.
4. One WM110 set will include one receiver and one transmitter.
5. 5 WM100 sets can work simultaneously in the same room without interferences.
However it is necessary that you leave a gap of at least 3 points between the channels
6. The
Φ3.5mm audio input is compatible with microphones, PCs, mobile phones
and MP3 players.
7. Charging is done by a USB type C cable.
8. Please do not remove the back clip on the backside of the receiver and transmitter.
9. The clip is part of the antenna module and will break if removed.
