IMPORTANT:
WE ADVISE YOU TO ASSEMBLE THE SCREEN HOUSE
ONCE BEFORE GOING CAMPING TO BECOME FAMILIAR WITH THE
ASSEMBLY.
NOTE:
PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE
HOW YOUR FRAME IS ASSEMBLED.
STEP 6:
Stake down Screen House by inserting the
metal stakes through the loops located at each
corner of the screen house. Hammer the stakes
into ground at a 45° angle, making sure the
screen house is pulled out even and snug with
the doors zipped closed.
STEP 7:
There are guy ropes located on the
four corners of the screen house. Extend
the guy ropes and make a loop at
opposite end of guy rope by using a
slider (as shown) and place the loop
over the stake. Adjust slider to make
guy rope tight and stake to the ground.
Screen
House
should
appear as shown.
NOTE:
To take down Screen house, follow steps above in the
reverse
order. Begin by sliding and folding the lower
hinge one corner
at a time. Next unlock the center
hub by pressing down on it
and twisting the center
clockwise. As the frame is folded inward
the
screen house fabric should be folded inward toward the center
to distribute the bulk . Lay the screen house on its side and roll it
with pressure to reduce its size and remove any excess air.
Once rolled, tie a string or rope around screen house to hold it
in place.
Place stakes into stake bag which is
provided. Place the screen
house and stakes into
carry bag. Make sure it is clean and dry
before storing.
STEP 1:
Set the Screen House on the ground and hold the center
hub in one hand.
STEP 2:
Unfold the poles so that they are flat on
the ground
STEP 3:
Gently squeeze the poles together just below
the hub and twist the orange piece on top of the
hub clockwise to unlock the poles. Fold the four
poles outward from the hub.
STEP
4:
Extend the hinges at
between the upper two pole
sections and push down on the
outer edge of the hub to lock
it in place. The center of the hub
will twist and lock automatically
when the poles are positioned
correctly.
STEP 5:
Extend the hinges between the two lower
pole sections. Be sure that the hinge slides and
locks into the extended position.
ITEM NO
.:
OP3459
