![background image](http://html.mh-extra.com/html/gmax/hm-et01/hm-et01_quick-installation-manual_2235113001.webp)
1
2
3
4
Quick Installation Guide
Ver. 1.0
All brand names and trademarks are properties of
their respective owners
Extend HD AV to 70m
over One Cat5e/6 Cable
FEATURES:
INTRODUCTION:
The Extender is based on the HDBaseT technology. It extends your
HD display with the resolutions of 1080p/60Hz up to 230 feet (70
meters) away from your HDMI or DVI-D source using one CAT5e/6
cable. It also provides an IR back channel to control AV sources
using the same CAT5e/6 cable. Built-in IR extender function Allows
IR remote control of Source devices from remote viewing location
by sending IR commands received in the vicinity of the Display
back to the Source devices.
Dear customer
Thank you for purchasing this product. For optimum performance and
safety, please read these instructions carefully before connecting, operating
or adjusting this product. Please keep this manual for future reference.
● Support 3D pass-through.
● Support CEC pass-through.
● Supports uncompressed audio such as LPCM.
● Supports compressed audio such as DTS Digital, Dolby Digital
(including DTS-HD and Dolby True HD).
● Built-in IR extender function allows IR remote control of Source
devices from remote viewing location by sending IR commands
received in the vicinity of the Display back to the Source devices.
● CAT5e/6 cable follows the standard of IEEE-568B.
PANEL DESCRIPTIONS:
Sender
PACKAGE CONTENTS:
Before attempting to use this unit, please check the packaging and
make sure the following items are contained in the shipping carton:
1) Main unit Sender X1
2) Main unit Receiver X1
3) Two pieces of 5VDC Power Supply.
4) IR(Extender infrared receiver) X1
5) IE(Extender infrared emitter) X1
6) User’s Manual
● Support HDCP
● Support uncompressed HDMI signal.
● Enables HDMI10.2 Gbps and IR control signal in parallel over a
single 70m Cat5e/6 cable.
● Supports 340MHz/3.4Gbps per channel (10.2Gbps all channel)
bandwidth.
● Support 1080p@60Hz@48bit pixels
Front
DC/5V:
External power adapter input
HDBaseT:
Connect the Sender to the Receiver using a Cat5e/6 cable.
Active:
When LED is “Blinking”, it indicates sender is boot up, and goes active.
Link:
When LED is “ON”, it indicates HDBaseT link connection established
between the Sender and the Receiver over the Cat5e/6 cable.
HDCP:
When the LED is “ON”, it indicates a video content with HDCP
protection is being transferred.
When LED is “Blinking”, it indicates a video content without HDCP.
When LED is “OFF”, it indicates no video is connected.
Power:
The LED will turn on to indicate the Sender is power on.
IR Emitter:
Connect Extender infrared emitter cable from this port to the HDMI
Source to control the source from the viewing location.