®
LTR-S-TUNtapeINST
PAGE 1
Dry Location
Dry location is a designation that usually means ‘in-
door’. LTR Series dry location tape is presented in a
copper bus that is not encapsulated with a silicone
sheath. To insure proper operation, install only in
locations that are not exposed to moisture, steam,
inclement weather or leaks of any type.
Wet location not available.
Turn Power Off at Circuit
Breaker Before Installing
Prior to installation, verify that all components (LED
tape, connectors, mounting clips, channels, power
supplies and controllers) are compatible.
Verify
that power is off before proceeding.
Determine Location and
Prepare Mounting Surface
Locate area where 24VDC LineDRIVE
non-dimmable
power supply is to be mounted.
Make sure area is clean and free of dust and any
debris that may hamper installation or get in the
way of wiring. Please make sure that the wire
gauge that you select has voltage drop, amperage
rating and type (in-wall, dry or wet location, etc.)
factored in.
Layout and Pre-Configure
Components Before You
Begin Installation
Locate area where LineDRIVE
non-dimmable
power supply and controller are to be mounted.
Make sure that this space is free of obstructions and
can be easily reached or mounting or maintenance.
WARNING!
FAMILIARIZE YOURSELF WITH
INSTRUCTIONS BEFORE PROCEEDING.
USE ONLY GM LIGHTING LineDRIVE
24VDC NON-DIMMING DRIVERS TO
ACTIVATE 5-YEAR WARRANTY.
FOLLOW ALL LOCAL CODES.
LEDTask™ Flexible LED Tape
LTR-S Series
Dry Location CCT Tunable LED Tape
90
C R I
+
DRY
L O C A T I O N
FIELD
C U T T A B L E
24
VOLT
2
CLASS
24
TITLE
5 Yr.
WARRANTY
TUNABLE
*
Use your mind before you unwind!
Please follow all applicable NEC
and local wiring codes.
Follow maximum length
tolerances when using tape.
Max. Length = maximum run length from
one power feed.
*Title 24 when used with select drivers.
See www.gmlighting.net
Verify that power is off
before proceeding.
